1. Which address type is automatically created by default on a host interface when no RAs are received? global unicast address link-local address MAC address 2. Which method best describes stateless DHCP? SLAAC only SLAAC with stateless DHCPv6 Server Stateful DHCPv6 Server

1. Which message is sent by a DHCPv4 client to initiate the lease obtaining process? DHCPDISCOVER DCHPOFFER DHCPREQUEST DHCPACK 2. Which two DHCPv4 messages are sent by the server in the lease obtaining process? (Choose two.) DHCPDISCOVER DCHPOFFER DHCPREQUEST DHCPACK 3. Which two DHCPv4 messages are used in …

1. Which are benefits of EtherChannel technology? (Choose all that apply.) fault-tolerance load sharing increased bandwidth link redundancy 2. True or False? FastEthernet and GigabitEthernet links can be combined into a single EtherChannel. True False 3. True or False? PAgP and LACP are both Cisco-proprietary link aggregation protocols. …

1. Which three STP port states are merged into the RSTP discarding port state? (Choose three.) disabled blocking listening learning forwarding 2. Which protocol was designed to bring faster convergence to STP? PortFast RSTP PVST MSTP 3. Which technology solves the problem of a device being unable to …

1. By default (without any configuration on a switch), what will determine which switch is the root bridge? The bridge priority The extended system ID The MAC address of the switch The bridge ID 2. The root bridge will be the switch with the: Lowest bridge ID Highest …

1. Which statement describes STP? STP is a Layer 2 routing protocol. STP is a Layer 3 routing protocol for Ethernet LANs. STP is a Layer 2 loop prevention protocol for Ethernet LANs. STP is a Layer 3 loop prevention protocol for IP networks. 2. Without STP on …

1. You are troubleshooting an inter-VLAN issue on a switch and need to verify that the subinterfaces are in the routing table. Which inter-VLAN routing troubleshooting command would you use to do this? show interfaces show interfaces interface-id switchport show ip interface brief show ip route show vlan …

Refer to each of the scenario topologies. Which statements best describe the different types of inter-VLAN routing solutions? (Choose all that apply.) Scenario A Scenario B Scenario C  Scenario A is a legacy inter-VLAN solution. Scenario B is a Layer 3 inter-VLAN solution. Scenario B and C are …

1. True or false? DTP is an open standard IEEE protocol that specifies auto negotiation of switch trunk links. true false 2. What is the default switchport mode for Cisco Catalyst switches? access trunk dynamic auto dynamic desirable 3. True or false? Two switchports on a link both …

1. Refer to the exhibit Question 1 Topology. PC1 sends an ARP broadcast frame. Which PC will receive the ARP broadcast frame? PC2 PC3 PC4 PC5 PC6 2. Refer to the exhibit Question 2 Topology. PC2 sends an ARP broadcast frame. Which PCs will receive the ARP broadcast …