IT Questions Bank

IT Questions Bank 1

Refer to the exhibit. Which two commands need to be used on R1 and R2 to create a virtual link to and from area 0? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which two variables must match between two OSPF routers to form a neighbor adjacency? (Choose two.)
IT Questions Bank 3IT Administrator asked 4 years ago • ,
On an OSPF multiaccess network, which multicast address must a non-DR router use to send an LSU packet that contains new link-state information?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
What are two effective ways to prevent the EIGRP stuck-in-active problem? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which two EIGRP and MPLS implementation statements are true? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Refer to the exhibit. Router R1 is seeing routes that are advertised by router R2, and R2 is seeing routes that are advertised by R1. Which two statements are true when using EIGRP and an L3 MPLS VPN? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Refer to the exhibit. Routers A and B have EIGRP configured and automatic summarization has been disabled on both routers. Which two router commands should be used to summarize the attached routes, and to which interface is this command applied? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
An administrator wants to configure EIGRPv6 in an IPv6 network. Which three statements are valid for the configuration of EIGRPv6? (Choose three.)
IT Questions Bank 3IT Administrator asked 3 years ago • 
Which two OSPF routing protocol characteristics can be used or modified at redistribution points to help implement a path control strategy? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
What is a characteristic of ADSL?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which two OSPFv3 statements are true? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which three statements are correct about the properties of an OSPF point-to-multipoint network type? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Which two tasks should be conducted during the PPDIOO Prepare phase? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
When the command distribute-list 1 in serial 0/0 is used, which routing updates would be permitted?
IT Questions Bank 2ITExamAnswers asked 1 year ago • 
Multiple paths exist in the BGP table. Assuming the weights are the same, what will the next determining factor be?
IT Questions Bank 3IT Administrator asked 3 years ago • , ,
« Previous1…333334335336337…1,320Next »
Ask Question