IT Questions Bank The following line was displayed in the output of the show ip route command. R 192.168.3.0/24 [120/3] via 192.168.2.2, 00:00:30, Serial0/0 What is the value of the routing metric?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What can be concluded from the routing table output of router B?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network consists of multiple routers. What can be verified when the show ip protocols command is issued on one of the routers in the network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers in the exhibit are running RIP v1. The network administrator issues the show ip route command on router A. What routes would appear in the routing table output if the network is converged? (Choose two).ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Router1 and Router2 are running the RIPv1 protocol. The network administrator configures the command network 10.1.0.0 on Router1. What network will Router1 advertise to Router2?ITExamAnswers asked 2 years ago • CCNA 2 v4What will happen if an interface IP address is entered for the address portion of the network command in a RIPv1 configuration instead of a network address?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are configured with valid interface addresses in the indicated networks and are running RIPv1. The network is converged. Which routes are present in the routing tables?ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following would be the correct command sequence to enable RIP on Router B for all connected networks?ITExamAnswers asked 2 years ago • CCNA 2 v4What are three characteristics of the RIPv1 routing protocol? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following is considered a limitation of RIP v1?ITExamAnswers asked 2 years ago • CCNA 2 v4What is the default update period in seconds for the RIP routing protocol?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still in the Router1 routing table. How much longer will Router1 keep the down network in its routing table before marking it as possibly down?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the output from the show ip route command. What can be concluded from the output of this router command?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The network that is shown is running RIPv1. The 192.168.10.0/24 network was recently added and will only contain end users. What command or set of commands should be entered on Router1 to prevent RIPv1 updates from being sent to the end user devices on the new network while still allowing this new network to be advertised to other routers?ITExamAnswers asked 2 years ago • CCNA 2 v4What is the purpose of the TTL field in the IP header?ITExamAnswers asked 2 years ago • CCNA 2 v4