IT Questions Bank

IT Questions Bank 1

Refer to the exhibit. Both routers R1 and R2 are configured for OSPFv3 and are routing for both IPv4 and IPv6 address families. Which two destination addresses will R1 use to establish a full adjacency with R2? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. Router R1 was configured by a network administrator to use SNMP version 2. The following commands were issued: Why is the administrator not able to get any information from R1?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. The total number of packet flows is not consistent with what is expected by the network administrator. The results show only half of the flows that are typically captured for the interface. Pings between the router and the collector are successful. What is the reason for the unexpected results?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. A network administrator issues the command show bgp ipv6 unicast | begin Network to check the BGP table. Which statement describes the routes with an unspecified address (::) in the Next Hop column?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
When an unlabeled packet arrives at an MPLS-enabled router interface, which database is used to make a forwarding decision on the packet?
IT Questions Bank 6IT Administrator asked 3 years ago • 
Match the MPLS router type to its characteristic.
IT Questions Bank 6IT Administrator asked 3 years ago • 
Refer to the exhibit. A network administrator configured a class map as shown, but the traffic is not being classified as desired. Which conclusion can be drawn from this configuration?
IT Questions Bank 6IT Administrator asked 3 years ago • 
Refer to the exhibit. An administrator wants EIGRP on Router1 to load balance traffic to network 2001:db8:11:10::/64 across two interfaces. Currently traffic is using only interface GigabitEthernet0/1. A second route, not in the routing table, is available with a metric of 264000. What value is needed in the variance command to make EIGRP put the second route into the routing table?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. Routers R1 and R2 enable EIGRP on all of their interfaces. Which two conclusions can the field engineer draw from the outputs of the show ip route eigrp command on each router? (Choose two.)
IT Questions Bank 6IT Administrator asked 3 years ago • 
Refer to the exhibit. An administrator has entered the command default-information originate in OSPFv3 global configuration mode on R1, but R2 is not receiving a default route. What is the problem?
IT Questions Bank 6IT Administrator asked 3 years ago • 
Refer to the exhibit. Routers R1 and R2 are configured as shown. However, the show ipv6 ospf neighbor command reveals that there are no OSPFv3 neighbors established. What error in the configuration is preventing neighbor relationship from forming between the two routers?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. A network administrator has configured two-way redistribution on router R1. However, OSPF routes are not being redistributed into the EIGRP domain. What is causing this issue?
IT Questions Bank 6IT Administrator asked 3 years ago • 
What OSPF LSA type is used to advertise routes redistributed into an OSPF domain?
IT Questions Bank 6IT Administrator asked 3 years ago • 
Match the IPsec function with the description.
IT Questions Bank 6IT Administrator asked 3 years ago • 
Match the IPsec function with its description. (Not all options are used.)
IT Questions Bank 6IT Administrator asked 3 years ago • 
« Previous1…922923924925926…1,320Next »
Ask Question