Command
IP OSPF Network Nonbroadcast
Use
This command manually sets the OSPF network type to nonbroadcast. This is a default for frame-relay and ATM links. Neighbor statements are required to form adjacency.
The Nonbroadcast network type has a DR election.
Syntax
Router(config-if)#ip ospf network nonbroadcast
Example
In this example, we will configure R4 to use its default network type. First we’ll configure OSPF on R1, R3, and R4 for all interfaces.
R4(config-router)#router ospf 1 R4(config-router)#network 0.0.0.0 0.0.0.0 area 0
Next we’ll configure the frame-relay network to use its default nonbroadcast type.
R4(config)#int s0/0 R4(config-if)#ip ospf network nonbroadcast
After a couple minutes, R4 still doesn’t have any adjacencies
R4(config-router)#do show ip ospf neighbor R4(config-router)#
Notice that the OSPF network type is non_broadcast, so it will require unicast updates.
R4(config)#do show ip ospf interface s0/0 Serial0/0 is up, line protocol is up Internet Address 10.4.4.4/24, Area 0 Process ID 1, Router ID 4.5.5.5, Network Type NON_BROADCAST, Cost: 64 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 4.5.5.5, Interface address 10.4.4.4 No backup designated router on this network Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5 oob-resync timeout 120 Hello due in 00:00:25 Supports Link-local Signaling (LLS) Index 1/1, flood queue length 0 Next 0x0(0)/0x0(0) Last flood scan length is 0, maximum is 0 Last flood scan time is 0 msec, maximum is 0 msec Neighbor Count is 0, Adjacent neighbor count is 0 Suppress hello for 0 neighbor(s)
After we configure the neighbor statement, the adjacencies come up.
R4(config)#router ospf 1 R4(config-router)#neighbor 10.4.4.1 R4(config-router)#neighbor 10.4.4.3 R4(config-router)# *Mar 1 00:45:55.347: %OSPF-5-ADJCHG: Process 1, Nbr 133.133.133.133 on Serial0/0 from LOADING to FULL, Loading Done *Mar 1 00:45:55.359: %OSPF-5-ADJCHG: Process 1, Nbr 111.111.111.111 on Serial0/0 from LOADING to FULL, Loading Done