Command
Ctrl – Shift 6, X
Use
Suspends the telnet session.
Syntax
ctrl + shift + 6, then ‘X’
Example
In this example, a telnet session is initiated from R3 to R2.
R2#telnet 10.2.2.2 Trying 10.2.2.2 … OpenUser Access Verification Password:
A couple of quick commands are ran from the telnet session.
R2>enable Password:R2#show run | sec router router ospf 1 log-adjacency-changes network 10.0.0.0 0.255.255.255 area 0 R2#
The ctrl + shift + 6, x shortcut key is issued to suspend the telnet session.
R2# R3(config)#
Issuing the do resume 1 command from R3 will resume the telnet session to R2 that was suspended.
R3(config)#do resume 1 [Resuming connection 1 to 10.2.2.2 … ]R2#
A quick cycle through the command buffer shows some of the commands that were typed before suspending the session.
R2#enable