IT Exam Items Repository Which type of cable does a network administrator need to connect a PC to a switch to recover it after the Cisco IOS software fails to load?ITExamAnswers Editorial Team asked 6 years ago • CCNAWhile troubleshooting a connectivity problem, a network administrator notices that a switch port status LED is alternating between green and amber. What could this LED indicate?ITExamAnswers Editorial Team asked 6 years ago • CCNARefer to the exhibit. What media issue might exist on the link connected to Fa0/1 based on the show interface command?ITExamAnswers Editorial Team asked 6 years ago • CCNAWhich protocol or service sends broadcasts containing the Cisco IOS software version of the sending device, and the packets of which can be captured by malicious hosts on the network?ITExamAnswers Editorial Team asked 6 years ago • CCNARefer to the exhibit. Which S1 switch port interface or interfaces should be configured with the ip dhcp snooping trust command if best practices are implemented?ITExamAnswers Editorial Team asked 6 years ago • CCNARefer to the exhibit. Fill in the blank. There are ” 5*” broadcast domains in the topology.ITExamAnswers Editorial Team asked 6 years ago • CCNAWhat tool is important to consider for use when making hardware improvement decisions about switches?ITExamAnswers Editorial Team asked 6 years ago • CCNAWhat is the maximum wire speed of a single port on a 48-port gigabit switch?ITExamAnswers Editorial Team asked 6 years ago • CCNAWhen the installation of a network infrastructure is being planned, which technology will allow power to be provided via Ethernet cabling to a downstream switch and its connected devices?ITExamAnswers Editorial Team asked 6 years ago • CCNAMatch the function to the corresponding switch type. (Not all options are used.)ITExamAnswers Editorial Team asked 6 years ago • CCNARefer to the exhibit. Fill in the blank. How many collision domains are shown in the topology? 2ITExamAnswers Editorial Team asked 6 years ago • CCNAMatch the borderless switched network guidline description to the principle (not all options used)ITExamAnswers Editorial Team asked 6 years ago • CCNAWhich block of addresses would be the minimum to accommodate all of these devices if each type of device was on its own network?ITExamAnswers Editorial Team asked 6 years ago • CCNARefer to the exhibit. The network administrator needs to configure a default route on the Border router. Which command would the administrator use to configure a default route that will require the least amount of router processing when forwarding packets?ITExamAnswers Editorial Team asked 6 years ago • CCNAOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question. Why are the pings from PC0 to Server0 not successful?ITExamAnswers Editorial Team asked 6 years ago • CCNA