Command
Frame Interface-dlci
Use
This command sets frame-relay to only use a single DLCI. This is used for point-to-point links
Syntax
Router(config-if)#frame-relay interface-dlci <dlci>
Example
In this example, we will configure R1 to use an interface dlci of 104.
R1(config)#int s1/0 R1(config-if)#frame interface-dlci 104 R1(config-fr-dlci)#exit R1(config-if)#do ping 10.4.4.4 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.4.4.4, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 4/19/68 ms