IT Questions Bank In which situation would the use of a static route be appropriate?ITExamAnswers asked 4 years agoRefer to the exhibit. Which three statements are true about how router JAX will choose a path to the 10.1.3.0/24 network when different routing protocols are configured? (Choose three.)ITExamAnswers asked 4 years agoRefer to the exhibit. The networks connected to router R2 have been summarized as a 192.168.176.0/21 route and sent to R1. Which two packet destination addresses will R1 forward to R2? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. The router has been configured with these commands: What are the two results of this configuration? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. Which two statements are true about the loopback address that is configured on RouterB? (Choose two.)ITExamAnswers asked 4 years agoWhich pairing reflects a correct protocol-and-metric relationship?ITExamAnswers asked 4 years agoWhich statement is true, as relates to classful or classless routing?ITExamAnswers asked 4 years agoRefer to the exhibit. The network is converged. After link-state advertisements are received from Router_A, what information will Router_E contain in its routing table for the subnets 208.149.23.64 and 208.149.23.96?ITExamAnswers asked 4 years agoRefer to the exhibit. A network associate has configured the internetwork that is shown in the exhibit, but has failed to configure routing properly. Which configuration will allow the hosts on the Branch LAN to access resources on the HQ LAN with the least impact on router processing and WAN bandwidth?ITExamAnswers asked 4 years agoRefer to the exhibit. After a RIP route is marked invalid on Router_1, how much time will elapse before that route is removed from the routing table?ITExamAnswers asked 4 years agoWhat is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?ITExamAnswers asked 4 years agoA router receives information about network 192.168.10.0/24 from multiple sources. What will the router consider the most reliable information about the path to that network?ITExamAnswers asked 4 years agoWhich statement describes the process ID that is used to run OSPF on a router?ITExamAnswers asked 4 years agoA network administrator is trying to add a new router into an established OSPF network. The networks attached to the new router do not appear in the routing tables of the other OSPF routers. Given the information in the partial configuration shown below, what configuration error is causing this problem?ITExamAnswers asked 4 years agoWhat command sequence will configure a router to run OSPF and add network 10.1.1.0 /24 to area 0?ITExamAnswers asked 4 years ago