IT Questions Bank Refer to the exhibit. If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?ITExamAnswers asked 4 years agoWhen a router undergoes the exchange protocol within OSPF, in what order does it pass through each state?ITExamAnswers asked 4 years agoWhat two things will a router do when running a distance vector routing protocol? (Choose two.)ITExamAnswers asked 4 years agoWhat OSPF command, when configured, will include all interfaces into area 0?ITExamAnswers asked 4 years agoWhat are two benefits of using a single OSPF area network design? (Choose two.)ITExamAnswers asked 4 years agoWhich two statements about the OSPF Router ID are true? (Choose two.)ITExamAnswers asked 4 years agoWhich parameter or parameters are used to calculate OSPF cost in Cisco routers?ITExamAnswers asked 4 years agoRefer to the exhibit. The network administrator requires easy configuration options and minimal routing protocol traffic. What two options provide adequate routing table information for traffic that passes between the two routers and satisfy the requests of the network administrator? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. The network administrator must establish a route by which London workstations can forward traffic to the Manchester workstations. What is the simplest way to accomplish this?ITExamAnswers asked 4 years agoRefer to the exhibit. The speed of all serial links is E1 and the speed of all Ethernet links is 100 Mb/s. A static route will be established on the Manchester router to direct traffic toward the Internet over the most direct path available. What configuration on the Manchester router will establish a route toward the Internet for traffic that originates from workstations on the Manchester LAN?ITExamAnswers asked 4 years agoRefer to the exhibit. The company uses EIGRP as the routing protocol. What path will packets take from a host on the 192.168.10.192/26 network to a host on the LAN attached to router R1?ITExamAnswers asked 4 years agoWhich type of EIGRP route entry describes a feasible successor?ITExamAnswers asked 4 years agoWhich commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)ITExamAnswers asked 4 years agoWhich two statements describe the process identifier that is used in the command to configure OSPF on arouter? (Choose two.)ITExamAnswers asked 4 years ago