IT Questions Bank

IT Questions Bank 1

If two OSPF neighbors have formed complete adjacency and are exchanging link-state advertisements, which state have they reached?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which functionality does an SVI provide?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which IPv6 routing protocol uses multicast group FF02::9 to send updates?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. Given the output from the show ip eigrp topology command, which router is the feasible successor?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which command must you enter to enable OSPFV2 in an IPV4 network?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which two steps must you perform on each device that is configured for IPv4 routing before you implement OSPFv3?(Choose two)
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which option describes a difference between EIGRP for IPv4 and IPv6?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which value must you configure on a device before EIGRP for IPv6 can start running?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which definition of default route is true?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit . Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. If RTR01 is configured as shown, which three addresses will be received by other routers that are running EIGRP on the network?(choose three)
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which two statements about floating static routes are true? (Choose two)
IT Questions Bank 2ITExamAnswers asked 4 years ago
To enable router on a stick on a router subinterface, which two steps must you perform? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
« Previous1…1,2111,2121,2131,2141,215…1,316Next »
Ask Question