IT Questions Bank Refer to the exhibit. If R1 sends traffic to 192.168.10.45, the traffic is sent through which interface?ITExamAnswers asked 4 years agoServer1 and Server2 are unable to communicate with the rest of the network. Your initial check with system administrators shows that IP address settings are correctly configured on the server side. What could be an issue?ITExamAnswers asked 4 years agoWhich command can you enter to set the default route for all traffic to an interface?ITExamAnswers asked 4 years agoWhich command can you enter to verify that a BGP connection to a remote device is established?ITExamAnswers asked 4 years agoA network administrator is troubleshooting an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?ITExamAnswers asked 4 years agoA router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?ITExamAnswers asked 4 years agoWhich three statements about link-state routing are true? (Choose three.)ITExamAnswers asked 4 years agoUnder which two circumstances is a switch port that is configured with PortFast BPDU guard error-disabled? (Choose two.)ITExamAnswers asked 4 years agoWhich option is the master redundancy scheme for stacked switches?ITExamAnswers asked 4 years agoWhich three options are switch port config that can always avoid duplex mismatch error between the switches? (Choose three.)ITExamAnswers asked 4 years agoDrag and drop the MAC address types from the left onto the correct descriptions on the right?ITExamAnswers asked 4 years agoHow can you manually configure a switch so that it is selected as the root Switch?ITExamAnswers asked 4 years agoHow are VTP advertisements delivered to switches across the network?ITExamAnswers asked 4 years agoRefer to the exhibit, The VLAN configuration of S1 is not being in this VTP enabled environment. The VTP and uplink port configurations for each switch are displayed. Which two command sets, if issued, resolve this failure and allow VTP to operate as expected? (Choose two.)ITExamAnswers asked 4 years agoA router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, using the fewest physical interfaces and without decreasing network performance?ITExamAnswers asked 4 years ago