IT Questions Bank Refer to the exhibit. Why has this switch not been elected the root bridge for VLAN1?ITExamAnswers asked 4 years agoRefer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet 0/10 is not the root port for VLAN 2?ITExamAnswers asked 4 years agoA network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?ITExamAnswers asked 4 years agoRefer to the exhibit. Based on the information given, which switch will be elected root bridge and why?ITExamAnswers asked 4 years agoRefer to the exhibit. The two exhibited devices are the only Cisco devices on the network. The serial network between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three statements are true of these devices? (Choose three.)ITExamAnswers asked 4 years agoFor which two reasons might be you choose chassis aggregation instead of stacking switches? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. If the devices produced the given output, what is the cause of the EtherChannel problem?ITExamAnswers asked 4 years agoWhich two statements about stacking Cisco switches are true ?(choose two)ITExamAnswers asked 4 years agoWhich two pieces of information can be shared with LLDP TLVs? (Choose two)ITExamAnswers asked 4 years agoWhich option is the industry-standard protocol for EtherChannel?ITExamAnswers asked 4 years agoWhich RPVST+ port state is excluded from all STP operations?ITExamAnswers asked 4 years agoRefer to the exhibit. How should the FastEthernet0/1 port on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?ITExamAnswers asked 4 years agoBased on the output below, which two statements are true of the interfaces on Switch1? (Choose two.)ITExamAnswers asked 4 years agoAssuming the default switch configuration which vlan range can be added modified and removed on a cisco switch?ITExamAnswers asked 4 years agoWhich of the port is not part of STP protocol.ITExamAnswers asked 4 years ago