IT Questions Bank What two actions result from entering the network 192.168.1.0 command in RIP configuration mode on a router? (Choose two.)ITExamAnswers asked 4 years agoFill in the blank. Do not abbreviate. When configuring RIPng, the default-information originate command instructs the router to propagate a static default route.ITExamAnswers asked 4 years agoWhen does a link-state router send LSPs to its neighbors?ITExamAnswers asked 4 years agoRefer to the exhibit. A network administrator has issued the exhibited commands in an attempt to activate RIPng on interface gig0/0. What is causing the console message that is shown after RIP is enabled?ITExamAnswers asked 4 years agoWhen would a network administrator use the clear access-list counters command?ITExamAnswers asked 4 years agoWhich type of ACL statements are commonly reordered by the Cisco IOS as the first ACEs?ITExamAnswers asked 4 years agoWhat is the effect of configuring an ACL with only ACEs that deny traffic?ITExamAnswers asked 4 years agoRefer to the exhibit. What will happen to the access list 10 ACEs if the router is rebooted before any other commands are implemented?ITExamAnswers asked 4 years agoA network administrator issues the show vlan brief command while troubleshooting a user support ticket. What output will be displayed?ITExamAnswers asked 4 years agoWhich type of VPN routes packets through virtual tunnel interfaces for encryption and forwarding?ITExamAnswers asked 4 years agoWhich step in the link-state routing process is described by a router flooding link-state and cost information about each directly connected link?IT Administrator asked 4 years agoWhat command would be used as part of configuring NAT or PAT to identify an interface as part of the external global network?IT Administrator asked 4 years agoTo avoid purchasing new hardware, a company wants to take advantage of idle system resources and consolidate the number of servers while allowing for multiple operating systems on a single hardware platform. What service or technology would support this requirement?IT Administrator asked 4 years agoTo avoid purchasing new hardware, a company wants to take advantage of idle system resources and consolidate the number of servers while allowing for multiple operating systems on a single hardware platform. What service or technology would support this requirement?ITExamAnswers asked 4 years agoTwo OSPF-enabled routers are connected over a point-to-point link. During the ExStart state, which router will be chosen as the first one to send DBD packets?IT Administrator asked 4 years ago