IT Questions Bank Refer to the exhibit. The small company shown uses static routing. Users on the R2 LAN have reported a problem with connectivity. What is the issue?ITExamAnswers asked 4 years agoRefer to the exhibit. Which is the best way for PC A and PC B to successfully communicate with sites on the Internet?ITExamAnswers asked 4 years agoConsider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 How would an administrator test this configuration?ITExamAnswers asked 4 years agoWhat would be the first step in calculating a summarized route for 5 networks?ITExamAnswers asked 4 years agoRefer to the exhibit. Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?ITExamAnswers asked 4 years agoRefer to the exhibit. R1 receives a packet destined for the IP address 192.168.2.10. Out which interface will R1 forward the packet?ITExamAnswers asked 4 years agoRefer to the graphic. Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C?ITExamAnswers asked 4 years agoRefer to the exhibit. What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization?ITExamAnswers asked 4 years agoRefer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?ITExamAnswers asked 4 years agoOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question. Which PCs will receive the broadcast sent by PC-C?ITExamAnswers asked 4 years agoFill in the blank. Use the full command syntax. The ” show vlan brief* ” command displays the VLAN assignment for all ports as well as the existing VLANs on the switch.ITExamAnswers asked 4 years agoMatch the IEEE 802.1Q standard VLAN tag field with the description. (Not all options are used.)ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A router-on-a-stick configuration was implemented for VLANs 15, 30, and 45, according to the show running-config command output. PCs on VLAN 45 that are using the 172.16.45.0 /24 network are having trouble connecting to PCs on VLAN 30 in the 172.16.30.0 /24 network. Which error is most likely causing this problem?ITExamAnswers asked 4 years ago • CCNAA high school uses VLAN15 for the laboratory network and VLAN30 for the faculty network. What is required to enable communication between these two VLANs while using the router-on-a-stick approach?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator needs to configure router-on-a-stick for the networks that are shown. How many subinterfaces will have to be created on the router if each VLAN that is shown is to be routed and each VLAN has its own subinterface?ITExamAnswers asked 4 years ago • CCNA