IT Questions Bank What is a characteristic of a routed port on a Layer 3 switch?ITExamAnswers asked 4 years ago • CCNAInter-VLAN communication is not occurring in a particular building of a school. Which two commands could the network administrator use to verify that inter-VLAN communication was working properly between a router and a Layer 2 switch when the router-on-a-stick design method is implemented? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Based on the partial output that is displayed by the use of the show vlan command, which conclusion can be drawn for the Gi1/1 interface?ITExamAnswers asked 4 years agoRefer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PC2 cannot communicate with PC1. Based on the output, what is the possible cause of the problem?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. What is the problem with this configuration, based on the output of the router?ITExamAnswers asked 4 years agoRefer to the exhibit. In this network design, which connection or connections if any, add the VLAN ID number if host H1 sends information to host H2?ITExamAnswers asked 4 years agoIdentify the steps needed to configure a switch for SSH. The answer order does not matter. (Not all options are used.)ITExamAnswers asked 4 years ago • CCNAWhich event will take place if there is a port security violation on switch S1 interface Fa0/1?ITExamAnswers asked 4 years agoRefer to the exhibit. What can be determined about port security from the information that is shown?ITExamAnswers asked 4 years agoRefer to the exhibit. Port Fa0/2 has already been configured appropriately. The IP phone and PC work properly. Which switch configuration would be most appropriate for port Fa0/2 if the network administrator has the following goals?ITExamAnswers asked 4 years agoWhat is the effect of using the switchport port-security command?ITExamAnswers asked 4 years agoRefer to the exhibit. The network administrator wants to configure Switch1 to allow SSH connections and prohibit Telnet connections. How should the network administrator change the displayed configuration to satisfy the requirement?ITExamAnswers asked 4 years agoIf one end of an Ethernet connection is configured for full duplex and the other end of the connection is configured for half duplex, where would late collisions be observed?ITExamAnswers asked 4 years ago • CCNAIn which situation would a technician use the show interfaces switch command?ITExamAnswers asked 4 years agoWhich command is used to set the BOOT environment variable that defines where to find the IOS image file on a switch?ITExamAnswers asked 4 years ago • CCNA