IT Questions Bank

IT Questions Bank 1

Which command can be used to verify the contents of the LSDB in an OSPF area?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , , ,
What routing table descriptor is used to identify OSPF summary networks that originate from an ABR?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What type of OSPF LSA is originated by ASBRs to advertise external routes?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What OSPF LSA type is used to inform routers of the router ID of the DR in each multiaccess network in an OSPF area?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which two statements correctly describe OSPF type 3 LSAs? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
Which of the following is used to facilitate hierarchical scaling in OSPF?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which characteristic describes both ABRs and ASBRs that are implemented in a multiarea OSPF network?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
What is one advantage of using multiarea OSPF?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Which statement describes a multiarea OSPF network?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
Which command will provide information specific to OSPFv3 routes in the routing table?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which command will verify that a router that is running OSPFv3 has formed an adjacency with other routers in its OSPF area?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
Single area OSPFv3 has been enabled on a router via the ipv6 router ospf 20 command. Which command will enable this OSPFv3 process on an interface of that router?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator enters the command ipv6 router ospf 64 in global configuration mode. What is the result of this command?
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
What does a Cisco router use automatically to create link-local addresses on serial interfaces when OSPFv3 is implemented?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which three addresses could be used as the destination address for OSPFv3 messages? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
« Previous1…392393394395396…1,320Next »
Ask Question