IT Questions Bank Refer to the exhibit. Two routers are unable to establish an adjacency. What is possible cause for this?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The network administrator is planning IP addressing of a new network. What part of this addressing scheme must be changed to allow communication between hostA and the server?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What summarization should R2 use to advertise its LAN networks to R1?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to exhibit. All routers are advertised and fully operational on all routers. Which statement is true about the path that the data will take from router A to router B?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to exhibit. The network is using the RIPv2 routing protocol. If network 10.0.0.0 goes down, what mechanism will prevent Router1 from advertisting false routing information back to Router2?ITExamAnswers asked 2 years ago • CCNA 2 v4Router R1 is participating in the OSPF routing protocol as well as the EIGRP routing protocol. If R1 learns of network 192.168.10.0/24 from both the OSPF and internal EIGRP routing protocols, how will the route appear in the routing table of R1?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What is the cost of the route to the 172.16.2.128 network with the subnet mask of 255.255.255.128?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What OSPF packets will trigger the reset of the Dead Time counter?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Routers R1, R2, and R3 have four local LANs attached. What is a correct set of network commands that will cause OSPF to be enabled for any R1 interface that is connected to its subnets?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What does the “2″ stand for in the router ospf 2 statement?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which network command or set of commands will cause OSPF to be enabled for any R1 interface connected to the exhibited subnets?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What does the “O*E2″ from the “O*E2 0.0.0.0/0 [110/1] via 192.168.1.1, 00:05:34, Serial0/0″ line represent?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What must be received between neighbors to prevent the dead time that is shown in the exhibit from reaching zero?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The network administrator wants to set the router ID of Router1 to 192.168.100.1. What steps can the administrator take to accomplish this?ITExamAnswers asked 2 years ago • CCNA 2 v4What three parameters must be indentical between OSPF routers in order to form an adjacency? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4