IT Questions Bank Refer to the exhibit. How many routes are child routes?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. R1 and R2 are unable to establish an adjacency. What two configuration changes will correct the problem?(choose two)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator has configured R1 as shown, and all interfaces are functioning correctly. Aping from R1 to 172.16.1.1 fails.What could be the cause of this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network technician notes that there are missing EIGRP routes in the routing tables on each router in this network. Based on the exhibited output, what caused these missing routes?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are running RIPv1. The two networks 10.1.1.0/29 and 10.1.1.16/29 are unable to access ech other.What can be the cause of this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What needs to be done to allow these two routers to connect successfully ?ITExamAnswers asked 2 years ago • CCNA 2 v4A network is configured with the IP, IPX and Apple Talk protocols. Which routing protocol is recommended for this network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. R2 is configured correctly.The network administrator has configured R1 as shown. Which two facts are true about the forwarding of route information by R1 ?(choose two)ITExamAnswers asked 2 years ago • CCNA 2 v4What is one function of the bootstrap program during the router boot process?ITExamAnswers asked 2 years ago • CCNA 2 v4What is the advantage of configuring a static route with an exit interface instead of a next-hop address?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. To implement the RIPv2 protocol, the network administrator runs the command as displayed. However, the show ip protocols command fails to display any output. How can the administrator solve the problem that is indicated by the lack of output from this command?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The show cdp neighbors command was run at R1. Which two facts about the newly detected device can be determined from the output?(choose two)ITExamAnswers asked 2 years ago • CCNA 2 v4A sniffer program has captured a packet with a destination IP address of 224.0.0.10. Which protocol uses IP address?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Host A is having problems accessing server A. All routers have the same EIGRP configuration as router RTR-A. What should be done so that host A can access server A?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network designer is testing a prototype of WAN connection. All of the routers in the exhibit are configured for OSPF routing. The design requires that the path between routers A and D through ISP-A is the primary and the path through ISP-B serves as a backup. The designer notice that router A has two equal-cost paths to the LAN on router D. How can the designer correct this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4