IT Questions Bank The output of the Router# show interfaces serial 0/1 command displays the following: Serial0/1 is up, line protocol is down. What is the most likely cause for the line protocol being down?ITExamAnswers asked 2 years ago • CCNA 2 v4Why is it advisable to enter a next-hop IP address when creating a static route whose exit interface is an Ethernet network?ITExamAnswers asked 2 years ago • CCNA 2 v4A router has one static route to each destination network. Which two scenarios would require an administrator to alter the static routes that are configured on that router? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4What happens to a static route entry in a routing table when the outgoing interface is not available?ITExamAnswers asked 4 years ago • CCNA 2 v4Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v4Refer to the exhibit. What two commands are required to provide connectivity between the 192.168.1.0 and 10.0.0.0 networks without requiring recursive lookup? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following are displayed by the Router# show cdp neighbors command? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A company network engineer is assigned to establish connectivity between the two Ethernet networks so that hosts on the 10.1.1.0/24 subnet can contact hosts on the 10.1.2.0/24 subnet. The engineer has been told to use only static routing for these company routers. Which set of commands will establish connectivity between the two Ethernet networks?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which set of commands will configure static routes that will allow the WinterPark and the Altamonte routers to deliver packets from each LAN and direct all other traffic to the Internet?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Given the output in the exhibit, how would a clock rate be determined for this link?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. How will packets destined to the 172.16.0.0 network be forwarded?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What is the significance of the /8 in the route to the 10.0.0.0 network?ITExamAnswers asked 2 years ago • CCNA 2 v4The routers in the diagram use the subnet assignments shown. What is the most efficient route summary that can be configured on Router3 to advertise the internal networks to the cloud?ITExamAnswers asked 2 years ago • CCNA 2 v4What address can be used to summarize networks 172.16.1.0/24, 172.16.2.0/24, 172.16.3.0/24, and 172.16.4.0/24?ITExamAnswers asked 2 years ago • CCNA 2 v4A static route that points to the next hop IP will have what administrative distance and metric in the routing table?ITExamAnswers asked 2 years ago • CCNA 2 v4