IT Questions Bank A network administrator needs to provide administrative access for certain users. Which mode will allow users access to both the show and debug commands?ITExamAnswers asked 2 years ago • Network FundamentalsWhich three addresses are private IP addresses? (Choose three.)ITExamAnswers asked 2 years ago • Network FundamentalsWhat action is taken by a host on an Ethernet network when the host attempts to contact a remote host on another network?ITExamAnswers asked 2 years ago • Network FundamentalsDuring the encapsulation process, what identifiers are added at the transport layer?ITExamAnswers asked 2 years ago • Network FundamentalsWhich device should be used for enabling a host to communicate with another host on a different network?ITExamAnswers asked 4 years ago • Network FundamentalsWhich three commands will change the current configuration mode of a router? (Choose three.)ITExamAnswers asked 2 years ago • Network FundamentalsAn administrator needs management access to a switch from a remote offsite location. Which three configurations are required on the switch to allow the administrator to have remote access using either SSH or Telnet? (Choose three.)ITExamAnswers asked 2 years ago • Network FundamentalsWhat are two purposes for configuring a banner on a router? (Choose two.)ITExamAnswers asked 2 years ago • Network FundamentalsA PC can not connect to any remote websites, ping its default gateway, or ping a printer that is functioning properly on the local network segment. Which action will verify that the TCP/IP stack is functioning correctly on this PC?ITExamAnswers asked 2 years ago • Network FundamentalsWhat type of cable is being used if a network administrator is connecting two Cisco routers and uses the 100BaseTX standard?ITExamAnswers asked 2 years ago • Network FundamentalsWhich scenario describes a typical peer-to-peer network environment?ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. Each media link is labeled. What type of cable should be used to connect the different devices?ITExamAnswers asked 2 years ago • Network FundamentalsA technician makes several changes to the running configuration on a router, but the desired results are not achieved. The technician issues the reload command. What action will be taken by the router?ITExamAnswers asked 2 years ago • Network FundamentalsRefer to the exhibit. Which type of network design is shown?ITExamAnswers asked 2 years ago • Network FundamentalsWhat is the effect of the command copy running-config tftp?ITExamAnswers asked 2 years ago • Network Fundamentals