IT Questions Bank

IT Questions Bank 1

Which WAN topology provides a combination of simplicity quality, and availability?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Why does a switch flood a frame to all ports?
IT Questions Bank 2IT Administrator asked 4 years ago • 
When DHCP is configured on a router, which command must be entered so the default gateway is automatically distributed?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What is a network appliance that checks the state of a packet to determine whether the packet is legitimate?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which command on a port enters the forwarding state immediately when a PC is connected to it?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Refer to Exhibit. Which configuration must be applied to the router that configures PAT to translate all addresses in VLAN 200 while allowing devices on VLAN 100 to use their own IP addresses?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Refer to the exhibit. An administrator must configure interfaces Gi1/1 and Gi1/3 on switch SW11 PC-1 and PC-2 must be placed in the Data VLAN and Phone-1 must be placed in the Voice VLAN Which configuration meets these requirements?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Refer to the exhibit. Which switch becomes the root of the spanning tree for VLAN 110?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What is a difference between local AP mode and FlexConnect AP mode?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which technique is used by Cisco WLCs to minimize the time required on key exchanges during roaming by maintaining a database of clients and keys on behalf of bound APs, and providing those clients and keys to other controllers and bound APs as needed during roaming?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What information is needed by an AP for stateful switchover (SSO) using high availability with a standby WLC?
IT Questions Bank 2IT Administrator asked 4 years ago • 
An engineer has identified two signals that are 180 degrees out of phase . What can be determined about these two signals?
IT Questions Bank 2IT Administrator asked 4 years ago • 
A network administrator would like to ensure that router R1 is always elected the active router for an HSRP group. Which set of commands would ensure the required results?
IT Questions Bank 14ITExamAnswers asked 4 years ago • ,
A networking engineer is configuring an NTP client to have access to multiple NTP servers but wants one server to have priority over the others. Which command will achieve this?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which protocol operates at Layer 3 and is used for marking packets?
IT Questions Bank 2IT Administrator asked 4 years ago • 
« Previous1…974975976977978…1,320Next »
Ask Question