IT Questions Bank

IT Questions Bank 1

Which CEF component enables multiple actions to be performed in addition to allowing or dropping traffic?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Where does a Cisco switch store the MAC address table entries?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which router memory component is used by CEF to make packet forwarding decisions?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which is the correct description of a native VLAN on a Cisco switch?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What would be the source of the entries in the ARP table of a particular IPv4 host?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the difference between a routed switch port and a trunk port on a multilayer switch?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which Cisco router component performs process switching of packets?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is a feature of a Cisco switch SVI?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which packet forwarding process uses ternary content addressable memory (TCAM)?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What are two characteristics of a Layer 2 Ethernet switch access port? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. An engineer configured the New York router with state routes that point to the Atlanta and Washington sites. When command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?
IT Questions Bank 12Pepe Gutierrez commented 4 years ago • 
Refer to the exhibit. An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.
IT Questions Bank 13IT Administrator asked 4 years ago • 
Drag and drop the DHCP snooping terms from the left onto the descriptions on the right.
IT Questions Bank 13IT Administrator asked 4 years ago • 
A network engineer is examining the configuration of a router and notices that interface Gi0/0 has been configured with the ip address dhcp command. Which statement describes the IP address condition of this interface?
IT Questions Bank 13IT Administrator asked 4 years ago • 
What term describes holding packets in memory until resources become available to transmit them?
IT Questions Bank 13IT Administrator asked 4 years ago • 
« Previous1…1,0241,0251,0261,0271,028…1,320Next »
Ask Question