IT Questions Bank What command is used to verify the DLCI destination address in a Frame Relay static configuration?ITExamAnswers asked 4 years agoWhat are two characteristics of Frame Relay point-to-point subinterfaces? (Choose two.)ITExamAnswers asked 4 years agoWhat is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?ITExamAnswers asked 4 years agoRefer to the exhibit. Which statement describes DLCI 17?ITExamAnswers asked 4 years agoWhat occurs on a Frame Relay network when the CIR is exceeded?ITExamAnswers asked 4 years agoIt has become necessary to configure an existing serial interface to accept a second Frame Relay virtual circuit. Which of the following procedures are required to accomplish this task? (Choose three.)ITExamAnswers asked 4 years agoWhich command allows you to verify the encapsulation type (CISCO or IETF) for a Frame Relay link?ITExamAnswers asked 4 years agoUsers have been complaining that their Frame Relay connection to the corporate site is very slow. The network administrator suspects that the link is overloaded. Based on the partial output of the Router# show frame relay pvc command shown in the graphic, which output value indicates to the local router that traffic sent to the corporate site is experiencing congestion?ITExamAnswers asked 4 years agoWhich two statistics appear in show frame-relay map output? (Choose two.)ITExamAnswers asked 4 years agoRefer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show framerelay map command shown?ITExamAnswers asked 4 years agoRouterA is unable to reach RouterB. Both routers are running IOS version 12.0. After reviewing the command output and graphic, what is the most likely cause of the problem?ITExamAnswers asked 4 years agoWhich encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?ITExamAnswers asked 4 years agoWhich two options are valid WAN connectivity methods? (Choose two.)ITExamAnswers asked 4 years agoThe command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which of the following statements is true concerning this command?ITExamAnswers asked 4 years agoWhich protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end-to-end communications?ITExamAnswers asked 4 years ago