IT Questions Bank Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?ITExamAnswers asked 4 years agoWhich two actions influence the EIGRP route selection process? (Choose two)ITExamAnswers asked 4 years agoWhich two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two)ITExamAnswers asked 4 years agoWhich IPv6 address block sends packets to a group address rather than a single address?ITExamAnswers asked 4 years agoWhat is the primary effect of the spanning-tree portfast command?ITExamAnswers asked 4 years agoRouter A learns the same route from two different neighbors, one of the neighbor routers is an OSPF neighbor and the other is an EIGRP neighbor. What is the administrative distance of the route that will be installed in the routing table?ITExamAnswers asked 4 years agoWhat are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)ITExamAnswers asked 4 years agoWhich attribute does a router use to select the best path when two or more different routes to the same destination exist from two different routing protocols?ITExamAnswers asked 4 years agoWhat are two characteristics of a controller-based network? (Choose two)ITExamAnswers asked 4 years agoWhat is a benefit of using a Cisco Wireless LAN Controller?ITExamAnswers asked 4 years agoA Cisco IP phone receive untagged data traffic from an attached PC. Which action is taken by the phone?ITExamAnswers asked 4 years agoWhat is the primary different between AAA authentication and authorization?ITExamAnswers asked 4 years agoWhich output displays a JSON data representation?ITExamAnswers asked 4 years agoWhich configuration is needed to generate an RSA key for SSH on a router?ITExamAnswers asked 4 years agoA frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two)ITExamAnswers asked 4 years ago