IT Questions Bank Which of the statements correctly describes cybersecurity?ITExamAnswers asked 9 months ago • Introduction to CybersecurityWhich of the following is an example of two factor authentication?ITExamAnswers asked 2 years ago • Introduction to CybersecurityWhat action will an IDS take upon detection of malicious traffic?ITExamAnswers asked 2 years ago • Introduction to CybersecurityRefer to the exhibit. The hosts that are connected to RTRB are not able to reach hosts connected to RTRA. Based on the configuration, what could be the problem?ITExamAnswers asked 9 months ago • CCNA 2 v4A network administrator has configured a default route on Router_A but it is not being shared with adjacent Router_B and the other routers in the OSPF area. Which command will save the administrator the time and trouble of configuring this default route on Router_B and all of the other routers in the OSPF area?ITExamAnswers asked 9 months ago • CCNA 2 v4Refer to the exhibit. What are the effects of the exhibited commands on the router?ITExamAnswers asked 9 months ago • CCNA 2 v4On a router, which actions can be performed in user mode?ITExamAnswers asked 9 months ago • CCNA 2 v4If a router is booting with its default configuration register setting and its NVRAM lacks boot system commands, from where will the router try to load the IOS image first?ITExamAnswers asked 9 months ago • CCNA 2 v4What does RIP use to reduce convergence time in a larger network?ITExamAnswers asked 9 months ago • CCNA 2 v4Refer to the exhibit. Hosts on the BOS Fa0/0 LAN are able to ping the Fa0/1 interface on the JAX router and all interfaces on the BOS and ORL routers. Why would hosts from the 10.0.0.0/24 network not be able to ping hosts on the Fa0/0 LAN of the JAX router?ITExamAnswers asked 9 months ago • CCNA 2 v4What happens if an EIGRP network path fails and DUAL cannot locate a suitable successor?ITExamAnswers asked 9 months ago • CCNA 2 v4Refer to the exhibit. Which route will be removed from the routing table if manual EIGRP summarization is disabled the Serial0/0/0 interface of R3?ITExamAnswers asked 9 months ago • CCNA 2 v4The network shown in the diagram is having problems routing traffic. It is suspected that the problem is with the addressing scheme. What is the problem with the addressing used in the topology?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What happens to a packet that has 172.16.0.0/16 as the best match in the routing table that is shown?ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following could describe the devices labeled “?” in the graphic? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v4