IT Questions Bank What is one function of a Layer 2 switch?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 3 v7, DevNet, Networking BasicsWhat are two advantages of modular switches over fixed-configuration switches? (Choose two.)ITExamAnswers asked 4 years ago • CCNA 2 v6A local law firm is redesigning the company network so that all 20 employees can be connected to a LAN and to the Internet. The law firm would prefer a low cost and easy solution for the project. What type of switch should be selected?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 3 v7What is a definition of a two-tier LAN network design?ITExamAnswers asked 4 years ago • CCNA 2 v6Which two previously independent technologies should a network administrator attempt to combine after choosing to upgrade to a converged network infrastructure? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 3 v7What is a collapsed core in a network design?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6A network designer must provide a rationale to a customer for a design that will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6What is a basic function of the Cisco Borderless Architecture distribution layer?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6What is different between IPv6 routing table entries compared to IPv4 routing table entries?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Which type of route requires a router to perform a recursive lookup?ITExamAnswers asked 2 years ago • CCNA 2 v6Which route is the best match for a packet entering a router with a destination address of 10.16.0.2?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Which two requirements are used to determine if a route can be considered an ultimate route in a router’s routing table? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6A destination route in the routing table is indicated with a code D. Which kind of route entry is this?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA SecurityHaving configured RIPv2 on an enterprise network, an engineer enters the command network 192.168.10.0 into router configuration mode. What is the result of entering this command?ITExamAnswers asked 2 years ago • CCNA 2 v6What is the purpose of the passive-interface command?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6