IT Questions Bank A network administrator uses the CLI to enter a command that requires several parameters. The switch responds with “% Incomplete command”. The administrator cannot remember the missing parameters. What can the administrator do to get the parameter information?ITExamAnswers asked 2 years ago • CCNA 3 v4Which command line interface (CLI) mode allows users to configure switch parameters, such as the hostname and password?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which hosts will receive a broadcast frame sent from Host A?ITExamAnswers asked 2 years ago • CCNA 3 v4Which layer of the hierarchical network design model is refered to as the high-speed backbone of the internetwork, where high availability and redundancy are critical?ITExamAnswers asked 2 years ago • CCNA 3 v4A technician is attempting to explain Cisco StackWise technology to a client that is setting up three stackable switches. Which explanation accurately describes StackWise technology?ITExamAnswers asked 2 years ago • CCNA 3 v4What statement best describes a modular switch?ITExamAnswers asked 2 years ago • CCNA 3 v4Link aggregation should be implemented at which layer of the hierarchical network?ITExamAnswers asked 2 years ago • CCNA 3 v4A network administrator is selecting a switch that will operate at the network core. Which three features should the switch support for optimum network performance and reliability? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4For organizations that are implementing a voice over IP solution, what functionality should be enabled at all three layers of the hierarchical network?ITExamAnswers asked 2 years ago • CCNA 3 v4At which heirarchical layer are switches normally not required to process all ports at wire speed?ITExamAnswers asked 2 years ago • CCNA 3 v4Which hierarchical design characteristic would be recommended at both the core and distribution layers to protect the network in the case of a route failure?ITExamAnswers asked 2 years ago • CCNA 3 v4A network technician is asked to examine an existing switched network. Following this examination, the technician makes recommendations for adding new switches where needed and replacing existing equipment that hampers performance. The technician is given a budget and asked to proceed. Which two pieces of information would be helpful in determining necessary port density for new switches? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which two features are supported at all three levels of the Cisco three-layer hierarchical model? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which layer of the OSI model does an access layer LAN switch use to make a forwarding decision?ITExamAnswers asked 2 years ago • CCNA 3 v4Configuring communication between devices on different VLANs requires the use of which layer of the OSI model?ITExamAnswers asked 2 years ago • CCNA 3 v4