IT Questions Bank Refer to the exhibit. The exhibited configurations do not allow the switches to form a trunk. What is the most likely cause of this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A can communicate with computer B, but not with computer C or computer D. What is the most likely cause of this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4If a network administrator enters these commands on a switch, what will be the result?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The switch and the hub have default configurations, and the switch has built its CAM table. Which of the hosts will capture a copy of the frame when workstation A sends a unicast packet to workstation C?ITExamAnswers asked 2 years ago • CCNA 3 v4Where is the startup configuration stored?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The network administrator has decided to allow only Secure Shell connections to Switch1. After the commands are applied, the administrator is able to connect to Switch1 using both Secure Shell and Telnet. What is most likely the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4What are two ways to make a switch less vulnerable to attacks like MAC address flooding, CDP attacks, and Telnet attacks? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. How many collision domains are depicted in the network?ITExamAnswers asked 2 years ago • CCNA 3 v4When a collision occurs in a network using CSMA/CD, how do hosts with data to transmit respond after the backoff period has expired?ITExamAnswers asked 2 years ago • CCNA 3 v4, Network FundamentalsWhich two statements are true about EXEC mode passwords? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which statement is true about the command banner login “Authorized personnel Only” issued on a switch?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two statements about Layer 2 Ethernet switches are true? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The exhibit shows partial output of the show running-config command. The enable password on this switch is “cisco.” What can be determined from the output shown?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The switch and workstation are administratively configured for full-duplex operation. Which statement accurately reflects the operation of this link?ITExamAnswers asked 2 years ago • CCNA 3 v4, Network FundamentalsWhen a switch receives a frame and the source MAC address is not found in the switching table, what action will be taken by the switch to process the incoming frame?ITExamAnswers asked 2 years ago • CCNA 3 v4