IT Questions Bank Refer to the exhibit. Beginning with HR servers and workstations, a network engineer is designing a new security structure for the network. Which set of policies adheres to the hierarchical network model design principles?ITExamAnswers asked 2 years ago • CCNA 3 v4What is the likely impact of moving a conventional company architecture to a completely converged network?ITExamAnswers asked 2 years ago • CCNA 3 v4Which hierarchical design model layer controls the flow of network traffic using policies and delineates broadcast domains by performing routing functions between virtual LANs (VLANs)?ITExamAnswers asked 2 years ago • CCNA 3 v4Which feature supports higher throughput in switched networks by combining multiple switch ports?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two characteristics are associated with enterprise level switches? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What characteristic of hierarchical network designs is exhibited by having SW3 connected to both SW1 and Sw2?ITExamAnswers asked 2 years ago • CCNA 3 v4A router has EIGRP configured as the only routing protocol. In what way might EIGRP respond if there is no feasible successor route to a destination network and the successor route fails?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator is accessing router R1 from the console port. Once the administrator is connected to the router, which password should the administrator enter at the R1> prompt to access the privileged EXEC mode?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The output of the show ip route command for router R1 is displayed. What action will the router take for a packet that is destined for 192.168.1.5?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which two components are required to complete the configuration? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator uses the RIP routing protocol to implement routing within an autonomous system. What are two characteristics of this protocol? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are properly configured to use the EIGRP routing protocol with default settings, and the network is fully converged. Which statement correctly describes the path that the traffic will use from the 10.1.1.0/24 network to the 10.1.2.0/24 network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Both routers are using the RIP protocol. Devices on the 192.168.1.1 network can ping the S0/0/0 interface on R2 but cannot ping devices on the 192.168.2.1 network. What is a possible cause of this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The routers are properly configured using a dynamic routing protocol with default settings, and the network is fully converged. Router A is forwarding data to router E. Which statement is true about the routing path?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The show cdp neighbors command was run at R1. Which two facts about the newly detected device can be determined from the output? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4