IT Questions Bank Refer to the exhibit. To implement the RIPv2 protocol, the network administrator runs the commands as displayed. However, the show ip protocol command fails to display any output. How can the administrator solve the problem that is indicated by the lack of output from this command?ITExamAnswers asked 2 years ago • CCNA 2 v4A network is configured with the IP, IPX, and AppleTalk protocols. Which routing protocol is recommended for this network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What action will R2 take for a packet that is destined for 192.168.2.0?ITExamAnswers asked 2 years ago • CCNA 2 v4Which two statements are true regarding link-state routing protocols? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4When a router boots, what is the default order to locate the Cisco IOS if there is no boot system command?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All router interfaces are configured with an IP address and are operational. If no routing protocols or static routes are configured, what information will be included in the show ip route command output for router A?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which router is advertising subnet 172.16.1.32/28?ITExamAnswers asked 2 years ago • CCNA 2 v4What is the function of the OSPF LSR packet?IT Administrator asked 4 years ago • CCNP, CCNA 2 v4Which two components are used to determine the router ID in the configuration of the OSPF routing process? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4What are two tasks that must be completed before two routers can use OSPF to form a neighbor adjacency? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Which two statements are correct about the split horizon with poison reverse method of routing loop prevention? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The network administrator is planning IP addressing of a new network. What part of this addressing scheme must be changed to allow communication between host A and the server?ITExamAnswers asked 2 years ago • CCNA 2 v4Which three statements describe the operation of routing with EIGRP? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4All routers in a network are configured in a single OSPF area with the same priority value. No loopback interface has been set on any of the routers. Which secondary value will the routers use to determine the router ID?ITExamAnswers asked 2 years ago • CCNA 2 v4Which statement is true about the RIPv1 protocol?ITExamAnswers asked 2 years ago • CCNA 2 v4