IT Questions Bank

IT Questions Bank 1

Refer to the exhibit. Which action resolves the adjacency issue?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. Which two commands provide the administrator with the information needed to resolve the issue? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
What is a characteristic of Layer 3 MPLS VPNs?
IT Questions Bank 2IT Administrator asked 3 years ago • 
What does the MP-BGP OPEN message contain?
IT Questions Bank 2IT Administrator asked 3 years ago • 
What statement about route distinguishes in an MPLS network is true?
IT Questions Bank 2IT Administrator asked 3 years ago • 
The network administrator configured R1 for Control Plane Policing so that the inbound Telnet traffic is policed to 100 kbps. This policy must not apply to traffic coming in from 10.1.1.1/32 and 172.16.1.1/32. The administrator has configured this: The network administrator is not getting the desired results. Which set of configurations resolves this issue?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Which mechanism provides traffic segmentation within a DMVPN network?
IT Questions Bank 2IT Administrator asked 3 years ago • 
R1 and R2 are configured as eBGP neighbor , R1 is in AS100 and R2 is in AS200. R2 is advertising these networks to R1: The network administrator on R1 must improve convergence by blocking all subnets of 172.16.0.0/16 major network with a mask lower than 23 from coming in, Which set of configurations accomplishes the task on R1?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. The AP status from Cisco DNA Center Assurance Dashboard shows some physical connectivity issues from access switch interface G1/0/14. Which command generates the diagnostic data to resolve the physical connectivity issues?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. An engineer configures the router 10.1.100.10 for EIGRP autosummarization so that R1 should receive the summary route of 10.0.0.0/8. However, R1 receives more specific /24 routes. Which action resolves this issue?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. Although summarization is configured for R1 to receive 10.0.0.0/8. more specific routes are received by R1. How should the 10.0.0.0/8 summary route be received from the neighbor, attached to R1 via Fast Ethernet0/0 interface?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. R1 is configured with IP SLA to check the availability of the server behind R6 but it kept failing. Which configuration resolves the issue?
IT Questions Bank 2IT Administrator asked 3 years ago • 
Which 0S1 model is used to insert an MPLS label?
IT Questions Bank 2IT Administrator asked 3 years ago • 
The network administrator configured R1 to authenticate Telnet connections based on Cisco ISE using TACACS+. ISE has been configured with an IP address of 192.168.1.5 and with a network device pointing toward R1(192.168.1.1) with a shared secret password of Cisco123.
IT Questions Bank 2IT Administrator asked 3 years ago • 
Refer to the exhibit. After a security audit, the administrator implemented an ACL in the route reflector. The RR became unreachable from any router in the network. Which two actions resolve the issue? (Choose two.)
IT Questions Bank 2IT Administrator asked 3 years ago • 
« Previous1…823824825826827…1,321Next »
Ask Question