IT Questions Bank

IT Questions Bank 1

What are three advantages of using EtherChannel technology? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Which three interface parameters must match for an EtherChannel to form? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
When a range of ports is being configured for EtherChannel, which mode will configure PAgP so that it initiates the EtherChannel negotiation?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
An EtherChannel link using LACP was formed between two switches, S1 and S2. While verifying the configuration, which mode combination could be utilized on both switches?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is an accurate description of redundancy?
IT Questions Bank 2ITExamAnswers asked 5 years ago • 
An administrator is troubleshooting a switch and wants to verify if it is a root bridge. What command can be used to do this?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
What is one way to correct a spanning tree failure?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Which two statements describe a switch port that is configured with PortFast? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
When PVST is running over a switched network, which port state can participate in BPDU frame forwarding based on BPDUs received, but does not forward data frames?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Which three port states are used by Rapid PVST+? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
During the implementation of Spanning Tree Protocol, all switches are rebooted by the network administrator. What is the first step of the spanning-tree election process?
IT Questions Bank 2ITExamAnswers asked 5 years ago • ,
After the election of the root bridge has been completed, how will switches find the best paths to the root bridge?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Which port state will switch ports immediately transition to when configured for PortFast?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
An administrator was troubleshooting a router-on-a-stick topology and concluded that the problem was related to the configuration of VLANs on the router subinterfaces. Which two commands can the administrator use in the router to identify the problem? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is required to perform router-on-a-stick inter-VLAN routing?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
« Previous1…834835836837838…1,321Next »
Ask Question