IT Questions Bank

IT Questions Bank 1

A network administrator uses the spanning-tree portfast bpduguard default global configuration command to enable BPDU guard on switch. However, BPDU guard is not activated on all access ports. What is the couse of the issue?
IT Questions Bank 2IT Administrator asked 3 years ago • 
A network administrator uses the spanning-tree portfast bpduguard default global configuration command to enable BPDU guard on a switch. However, BPDU guard is not activated on all access ports. What is the cause of the issue?
IT Questions Bank 3ITExamAnswers asked 4 years ago • ,
What is the goal of an attack in the installation phase of the Cyber Kill Chain?
IT Questions Bank 3ITExamAnswers asked 4 years ago • 
Which technology is a major standard consisting of a pattern of symbols that describe data to be matched in a query?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What is blacklisting?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What does the incident handling procedures security policy describe?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What are three functionalities provided by SOAR? (Choose three.)
IT Questions Bank 2IT Administrator asked 4 years ago • 
An administrator discovers a vulnerability in the network. On analysis of the vulnerability the administrator decides the cost of managing the risk outweighs the cost of the risk itself. The risk is accepted, and no action is taken. What risk management strategy has been adopted?
IT Questions Bank 2IT Administrator asked 4 years ago • 
A technician configured a switch with console, enable secret, and VTY passwords. The service password-encryption command was then used to encrypt all unencrypted passwords. What happens if the technician issues the no service password-encryption command?
IT Questions Bank 3ITExamAnswers asked 3 years ago • 
A computer technician is monitoring traffic on a network where users are complaining about slow network performance. The technician is curious as to whether the new network management software is causing the slowdown. Which two port numbers would the technician be looking for in the captured packets for SNMP traffic? (Choose two.)
IT Questions Bank 3ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. Which SNMP authentication password must be used by the member of the ADMIN group that is configured on router R1?
IT Questions Bank 3ITExamAnswers asked 3 years ago • 
A teacher is explaining uRPF to network students in a classroom. Which two statements are accurate about uRPF operation on a Cisco router? (Choose two.)
IT Questions Bank 3ITExamAnswers asked 3 years ago • 
Which action is necessary to provide encrypted transfer of data between a RADIUS server and a AAA-enabled router?
IT Questions Bank 3ITExamAnswers asked 3 years ago • 
What is the recommended action when troubleshooting scenarios for CoPP, where specific source and destination IP addresses are used in the ACL?
IT Questions Bank 3ITExamAnswers asked 3 years ago • 
A junior engineer is learning how to apply a service policy to a Cisco router control plane. Which piece of information should be considered to perform this configuration?
IT Questions Bank 3ITExamAnswers asked 3 years ago • 
« Previous1…949950951952953…1,321Next »
Ask Question