7.4.1.2 Packet Tracer – Skills Integration Challenge Instructions Answers

Packet Tracer – Skills Integration Challenge

Addressing Table

Scenario

In this challenge activity, you will finish the addressing scheme, configure routing, and implement named access control lists.

Requirements

a. Divide 172.16.128.0/19 into two equal subnets for use on Branch.

  1. Assign the last usable address of the second subnet to the Gigabit Ethernet 0/0 interface.
  2. Assign the last usable address of the first subnet to the Gigabit Ethernet 0/1 interface.
  3. Document the addressing in the Addressing Table.
  4. Configure Branch with appropriate addressing

b. Configure B1 with appropriate addressing using the first available address of the network to which it is attached.         Document the addressing in the Addressing Table.

c. Configure HQ and Branch with RIPv2 routing according to the following criteria:

  • Advertise all three attached networks. Do not advertise the link to the Internet.
  • Configure appropriate interfaces as passive.

d. Set a default route on HQ which directs traffic to S0/0/1 interface. Redistribute the route to Branch.

e. Design a named access list HQServer to prevent any computers attached to the Gigabit Ethernet 0/0 interface of     the Branch router from accessing pka. All other traffic is permitted. Configure the access list on the appropriate       router, apply it to the appropriate interface and in the appropriate direction.

f. Design a named access list BranchServer to prevent any computers attached to the Gigabit Ethernet 0/0                  interface of the HQ router from accessing the Branch server. All other traffic is permitted. Configure the access        list on the appropriate router, apply it to the appropriate interface and in the appropriate direction.

 


Related Articles

2
Leave a Reply

avatar
2 Comment threads
0 Thread replies
0 Followers
 
Most reacted comment
Hottest comment thread
2 Comment authors
JordiHeyyou Recent comment authors
newest oldest most voted
Jordi
Guest
Jordi

HQ ACL
HQ(config)#ip access-list standard HQServer
HQ(config-std-nacl)#deny 172.16.144.0 0.0.15.255
HQ(config-std-nacl)#permit any
HQ(config-std-nacl)#exit
HQ(config)#int g0/1
HQ(config-if)#ip access-group HQServer out
HQ(config-if)#exit

Branch ACL:
Branch(config)#ip access-list standard BranchServer
Branch(config-std-nacl)#deny 172.16.64.0 0.0.63.255
Branch(config-std-nacl)#permit any
Branch(config-std-nacl)#exit
Branch(config)#int g0/1
Branch(config-if)#ip access-group BranchServer

Heyyou
Guest
Heyyou

Also does not contain answers…..