Time limit: 0
Quiz-summary
0 of 56 questions completed
Questions:
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- 27
- 28
- 29
- 30
- 31
- 32
- 33
- 34
- 35
- 36
- 37
- 38
- 39
- 40
- 41
- 42
- 43
- 44
- 45
- 46
- 47
- 48
- 49
- 50
- 51
- 52
- 53
- 54
- 55
- 56
Information
CCNP ROUTE Final Test online (Version 7)
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
Results
0 of 56 questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 points, (0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- 27
- 28
- 29
- 30
- 31
- 32
- 33
- 34
- 35
- 36
- 37
- 38
- 39
- 40
- 41
- 42
- 43
- 44
- 45
- 46
- 47
- 48
- 49
- 50
- 51
- 52
- 53
- 54
- 55
- 56
- Answered
- Review
-
Question 1 of 56
1. Question
1 pointsRefer to the exhibit. All routers are configured for OSPF area 0. The network administrator requires that R2 always be the DR and maintain adjacency. Which two configurations can achieve this? (Choose two.)Correct
Incorrect
-
Question 2 of 56
2. Question
1 pointsRefer to the exhibit. Routers A and B have EIGRP configured and automatic summarization has been disabled on both routers. Which two router commands should be used to summarize the attached routes, and to which interface is this command applied? (Choose two.)Correct
Incorrect
-
Question 3 of 56
3. Question
1 pointsRefer to the exhibit. Router R1 is seeing routes that are advertised by router R2, and R2 is seeing routes that are advertised by R1. Which two statements are true when using EIGRP and an L3 MPLS VPN? (Choose two.)Correct
Incorrect
-
Question 4 of 56
4. Question
1 pointsWhich two EIGRP and MPLS implementation statements are true? (Choose two.)Correct
Incorrect
-
Question 5 of 56
5. Question
1 pointsWhat are two effective ways to prevent the EIGRP stuck-in-active problem? (Choose two.)Correct
Incorrect
-
Question 6 of 56
6. Question
1 pointsOn an OSPF multiaccess network, which multicast address must a non-DR router use to send an LSU packet that contains new link-state information?Correct
Incorrect
-
Question 7 of 56
7. Question
1 pointsWhich two variables must match between two OSPF routers to form a neighbor adjacency? (Choose two.)Correct
Incorrect
-
Question 8 of 56
8. Question
1 pointsRefer to the exhibit. A network administrator is troubleshooting a recent OSPF stub configuration between R3 and R4. The only routes that should appear on the routing table for R4 are intra-area routes and the default route. However, interarea routes are also appearing. What must the administrator do to fix this problem?Correct
Incorrect
-
Question 9 of 56
9. Question
1 pointsRefer to the exhibit. Which two commands need to be used on R1 and R2 to create a virtual link to and from area 0? (Choose two.)Correct
Incorrect
-
Question 10 of 56
10. Question
1 pointsRefer to the exhibit. The BGP sessions are established between all routers. RTC receives route updates for network 170.10.0.0 from autonomous system 300 with the weight attribute set to 3000. RTB learns about network 170.10.0.0 from autonomous system 200 with a weight of 2000. Which router will be used by RTA as a next hop to reach network 170.10.0.0?Correct
Incorrect
-
Question 11 of 56
11. Question
1 pointsRefer to the exhibit. RTR-A and RTR-B cannot establish a BGP relationship. What could be the problem?Correct
Incorrect
-
Question 12 of 56
12. Question
1 pointsRefer to the exhibit. Assume router R2 does not have BGP enabled. However, the neighbor remote-as router configuration command has been entered on routers R1 and R3. Based on the information that is presented, which two statements are true? (Choose two.)Correct
Incorrect
-
Question 13 of 56
13. Question
1 pointsWhat is a characteristic of an IBGP session type?Correct
Incorrect
-
Question 14 of 56
14. Question
1 pointsRefer to the exhibit. Assume all routers are running BGP sessions and both links are operational. Which procedure would ensure that AS1 routers use link 1.1.1.1 for packet transmittal to AS2?Correct
Incorrect
-
Question 15 of 56
15. Question
1 pointsWhich statement about stateless autoconfiguration is true?Correct
Incorrect
-
Question 16 of 56
16. Question
1 pointsAssume that the ipv6 unicast-routing global configuration command has already been applied on a router. What is the effect of entering the ipv6 ospf 1 area 1 interface configuration command?Correct
Incorrect
-
Question 17 of 56
17. Question
1 pointsWhich ICMPv6 message provides prefix, prefix length and default gateway information for an IPv6 device?Correct
Incorrect
-
Question 18 of 56
18. Question
1 pointsWhich mechanism optimizes the TCP window size by multiplying the product of the bandwidth times the round-trip delay?Correct
Incorrect
-
Question 19 of 56
19. Question
1 pointsWhich command is used by a router to only announce a default route in it’s RIPng updates?Correct
Incorrect
-
Question 20 of 56
20. Question
1 pointsWhich type of address is used to send traffic to a group of devices?Correct
Incorrect
-
Question 21 of 56
21. Question
1 pointsWhat is the IPv4 multicast address used by EIGRP?Correct
Incorrect
-
Question 22 of 56
22. Question
1 pointsWhich VPN solution is used to better scale large IPsec hub-to-spoke and spoke-to-spoke networks?Correct
Incorrect
-
Question 23 of 56
23. Question
1 pointsWhat must be done before RIPng can be enabled?Correct
Incorrect
-
Question 24 of 56
24. Question
1 pointsIn which routing protocol and type of active interface automatically enabled for that routing protocol? Choose two.Correct
Incorrect
-
Question 25 of 56
25. Question
1 pointsWhich IGP routing protocols use a 32-bit router-ID? Choose all that apply.Correct
Incorrect
-
Question 26 of 56
26. Question
1 pointsWhich command is used to enable OSPFv3 using address families on an interface?Correct
Incorrect
-
Question 27 of 56
27. Question
1 pointsWhich statement is true concerning OSPF messages when using OSPFv3 with address families?Correct
Incorrect
-
Question 28 of 56
28. Question
1 pointsWhich IPv6 multicast addresses are used by OSPFv3?Correct
Incorrect
-
Question 29 of 56
29. Question
1 pointsRefer to the exhibit. Which two statements are correct for the route map that is shown? (Choose two.)Correct
Incorrect
-
Question 30 of 56
30. Question
1 pointsRefer to the exhibit. Which route redistribution statement is true?Correct
Incorrect
-
Question 31 of 56
31. Question
1 pointsWhich route map configuration command matches routes identified by an ACL or an prefix list?Correct
Incorrect
-
Question 32 of 56
32. Question
1 pointsWhich two networks would match the following prefix list? (Choose two.)ip prefix-list MATCHTHIS seq 5 deny 10.1.0.0/16 ge 24 le 30Correct
Incorrect
-
Question 33 of 56
33. Question
1 pointsRefer to the exhibit. Which three actions will be results of the distribute list that is shown? (Choose three.)Correct
Incorrect
-
Question 34 of 56
34. Question
1 pointsWhich routing updates would be permitted when the distribute-list 1 in serial 0/0/0 router configuration command is configured?Correct
Incorrect
-
Question 35 of 56
35. Question
1 pointsWhich set of commands correctly configures one-way route redistribution from OSPF into the EIGRP routing domain?Correct
Incorrect
-
Question 36 of 56
36. Question
1 pointsWhich two statements are correct about redistribution? (Choose two.)Correct
Incorrect
-
Question 37 of 56
37. Question
1 pointsWhich statement best describes the route filtering process used by route maps?Correct
Incorrect
-
Question 38 of 56
38. Question
1 pointsWhich two OSPF routing protocol characteristics can be used or modified at redistribution points to help implement a path control strategy? (Choose two.)Correct
Incorrect
-
Question 39 of 56
39. Question
1 pointsWhich routes will retain existing metrics when redistributed into EIGRP?Correct
Incorrect
-
Question 40 of 56
40. Question
1 pointsWhich two statements are true of policy-based routing (PBR) as a path control tool? (Choose two.)Correct
Incorrect
-
Question 41 of 56
41. Question
1 pointsRefer to the exhibit. The route map LOAD_BALANCE has been applied to the FastEthernet interfaces of R1, and all interfaces are up. R1 uses two default static routes to reach the Internet via ISP1 and ISP2. Which traffic will be sent to the null 0 interface by the route map on R1?Correct
Incorrect
-
Question 42 of 56
42. Question
1 pointsWhich command would allow the filtering of routes for the 10.0.0.0 255.255.0.0 network through the 10.0.255.0 255.255.255.0 network address space?Correct
Incorrect
-
Question 43 of 56
43. Question
1 pointsRefer to the exhibit. The network policy requires that packets from the 10.0.0.0/8 network be directed to R2 to and then the Internet? Given the following configuration: access-list 111 permit ip 10.0.0.0 0.255.255.255 any route-map net-10 permit 10 match ip address 111 set interface FastEthernet 0/1 On which router and which interface would the ip policy route-map command be configured?Correct
Incorrect
-
Question 44 of 56
44. Question
1 pointsWhat is the purpose of the Cisco IOS IP SLA feature?Correct
Incorrect
-
Question 45 of 56
45. Question
1 pointsWhich three of the following packets cannot be CEF switched and must be processed in software?Correct
Incorrect
-
Question 46 of 56
46. Question
1 pointsWhich router interface command would enable a router to acquire an IP address configuration from an upstream DHCP server?Correct
Incorrect
-
Question 47 of 56
47. Question
1 pointsThe IPv6 _____________________ interface ID is derived by splitting an interface’s 48-bit MAC address in two and inserting 0xFFFE in between the two parts.Correct
Incorrect
-
Question 48 of 56
48. Question
1 pointsUse this interface configuration command to enable the automatic configuration of an IPv6 address using stateless address autoconfiguration (SLAAC).Correct
Incorrect
-
Question 49 of 56
49. Question
1 pointsWhich protocol would you use to provide IPv4 Internet connectivity to IPv6 devices?Correct
Incorrect
-
Question 50 of 56
50. Question
1 pointsIn MP-BGP, what must be configured within an address family before a neighbor can be established?Correct
Incorrect
-
Question 51 of 56
51. Question
1 pointsWhich of the following regarding MP-BGP is not a true statement?Correct
Incorrect
-
Question 52 of 56
52. Question
1 pointsWhich statement about SNMP is true?Correct
Incorrect
-
Question 53 of 56
53. Question
1 pointsThe output of the show ip ssh command displays “SSH Enabled – version 2”. Based on this output, which statement is true?Correct
Incorrect
-
Question 54 of 56
54. Question
1 pointsWhich VRF statement is true?Correct
Incorrect
-
Question 55 of 56
55. Question
1 pointsWhich two routing protocol authentication statements are true? (Choose two.)Correct
Incorrect
-
Question 56 of 56
56. Question
1 pointsWhich statement about the Secure Copy (SCP) feature is true?Correct
Incorrect