Delay Command on CISCO Router/Switch

Command

Delay

Use

This command is used to logically set the delay of an interface, some protocols such as EIGRP use delay for its metric calculations..

Syntax

Router(config-if)#Delay <tens of microseconds>

Example

In this example we set R1’s Fa0/0 interface to have a delay of 200.

R1(config-if)#do show int fa0/0 | in DLY
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
R1(config-if)#
R1(config-if)#delay 200
R1(config-if)#do show int fa0/0 | in BW
MTU 1500 bytes, BW 768 Kbit, DLY 2000 usec,

Related Articles

Leave a Reply

avatar