3.2.2.4 Lab - Using a PL-App Notebook (Instructor Version) Lab Topology Objectives Access existing PL-App notebooks Lean how to interact with PL-App notebooks using keyboard shortcuts Create your own PL-App notebook Background The PL-App notebook concept is based on the Jupyter open source project that provides an interactive …

3.2.2.3 Lab - Setting up PL-App with a Raspberry Pi (Answers) Lab Topology Objectives Set up a Raspberry Pi board as a PL-App device Use PL-App Launcher to provision and discover PL-App devices Background Cisco Prototyping Lab is a set of hardware and software components that enable students …

2.2.4.3 Lab - Relays (Answers) Topology Objectives Set up the Relay circuit on the breadboard Load and run the sketch in the Arduino IDE Background / Scenario This lab will make use of a relay along with other components to serve as an electrically controlled mechanical switch. Required …

2.2.4.2 Lab - Flex Sensor and Servo (Instructor Version) Topology Objectives Connect the circuits between the breadboard and RedBoard Load and run the sketch in the Arduino IDE Background / Scenario This lab will make use of a special Flex Sensor to change resistance based on the amount …

2.2.3.2 Lab - Photo Resistor using Redboard and Arduino IDE (Instructor Version) Topology Objectives Configure the Photo Resistor circuit Load and run the sketch in the Arduino IDE Modify the sketch to adjust the light range Convert the sketch to make the circuit work as a night light …

2.2.2.6 Lab - RGB LED using RedBoard and Arduino IDE (Instructor Version) Topology Objectives Part 1: Set up the RGB circuit on the breadboard Connect the circuits between the breadboard and RedBoard Load and run the sketch in the Arduino IDE Background / Scenario Arduino, with its open …

2.2.2.5 Lab - Blinking an LED using RedBoard and Arduino IDE (Instructor Version) Topology Objectives Part 1: Setting up RedBoard Installing the Arduino IDE Connecting the RedBoard to the computer Configuring the Arduino IDE Blinking the LED on the RedBoard Part 2: Connect an external LED using a …

2.1.3.4 Lab - Designing a Circuit from Start to Finish (Instructor Version) Objectives Part 1: Use a breadboard to design a circuit in Autodesk 123D Lab View Create an account Create a new Electronics Lab Add components using the + Components button Modify the circuit Part 2: Design …

2.1.2.8 Lab - The Digital Oscilloscope (Instructor Version) Topology Objectives Use Falstad’s Web Circuit Simulation Tool to get familiar with waveforms and basic electronics components. Background / Scenario Electronics is deeply connected to IoT. In this lab you will use Falstad’s Web Circuit Simulatior to visualize waveforms. Secondarily, …

2.1.1.5 Lab - The World Runs on Circuits (Instructor Version) Topology Objectives Part 1: Create a Simple Circuit using a 9V Battery as its Power Source Part 2: Create a Simple Circuit using a 1.5V Battery (AA or D Cell) as its Power Source Background / Scenario In …