IT Questions Bank Refer to the exhibit. Router R2 has recently been configured and connected via interface Gigabit Ethernet 0/0 to router R1. R1 is configured correctly, but fails to establish a neighbor relationship with R2. What is the problem?IT Administrator asked 3 years ago • CCNA, CCNPWhen a link failure occurs on a network running EIGRP, how does DUAL determine a replacement route to a destination router?ITExamAnswers asked 1 year ago • CCNAA network administrator has just changed the router ID on a router that is working in an OSPFv2 environment. What should the administrator do to reset the adjacencies and use the new router ID?ITExamAnswers asked 4 years ago • CCNA, CCNPWhen OSPFv2 neighbors are establishing adjacencies, in which state do they elect a DR and BDR router?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPRefer to the exhibit. Which address will R1 use as the source address for all OSPFv3 messages that will be sent to neighbors?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich two addresses represent valid destination addresses for an OSPFv3 message? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhat are the only two roles that permit an OSPF router to be configured for summarization? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network engineer is preparing to upgrade the IOS system image on a Cisco 2901 router. Based on the output shown, how much space is available for the new image?ITExamAnswers asked 4 years ago • CCNAAfter a license has been purchased and installed, what is the next step that is required before it is activated?IT Administrator asked 3 years ago • CCNAWhich statement describes the Cisco License Manager?IT Administrator asked 3 years ago • CCNARefer to the exhibit. Users on the R1 LAN and R2 LAN are unable to communicate. Based on the IPv6 addressing of the network displayed, what is the problem?ITExamAnswers asked 1 year ago • CCNAWhat is the value used to determine which port on a non-root bridge will become a root port in a STP network?ITExamAnswers asked 4 years ago • CCNP, CCNAWhich three STP states were replaced with the RSTP discarding state? (Choose three.)ITExamAnswers asked 4 years ago • CCNAWhich IPv6 address is used by OSPFv3 as a next hop?ITExamAnswers asked 1 year ago • CCNPA switch console displays the message %SPANTREE2CHNL_MISCFG. What does this mean?ITExamAnswers asked 1 year ago • CCNP