IT Questions Bank A network administrator types the following command on a router: Which response would most likely be displayed after issuing this command?ITExamAnswers asked 1 year ago • CCNPA network administrator is troubleshooting a connectivity issue in a Layer 2 switched network. After issuing the show macaddresstable command on the access switch, the administrator observes that there is no entry for the host that is experiencing the problems. The host machine is powered on and appears to be functioning normally. What can be deduced from this?ITExamAnswers asked 1 year ago • CCNPWhich three types of ports or interfaces can be affected by the Spanning Tree Protocol? (Choose three.)ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A forwarding loop has been created between switches A, B, and D. Given the output generated by the show spanning-tree vlan command on switches B and D, what could be the cause of the problem?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator is unable to ping between two workstations, PC1 and PC2, that are connected to switch3548. PC1 is connected to port Fa0/23, and PC2 is connected to port Gi0/2. Given the output of the show vlan command, which statement is true?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. Which two conclusions can be made based on the output of the show mac address-table command?(Choose two.)ITExamAnswers asked 1 year ago • CCNPA router is currently running both OSPF and BGP. The administrator issues the command show ip route | exclude ^B. What routes will be displayed?ITExamAnswers asked 1 year ago • CCNPWhich two features apply to MSTP? (Choose two.)ITExamAnswers asked 1 year ago • CCNPHow do you configure a specific interface for EIGRP in IPv6?ITExamAnswers asked 1 year ago • CCNPWhich command enables you to display the IPv6 BGP table?ITExamAnswers asked 1 year ago • CCNPHow can you include an interface into an OSPFv3 process for IPv4 address family?ITExamAnswers asked 1 year ago • CCNPWhich command enables you to display IPv6 – MAC mappings on the router?ITExamAnswers asked 1 year ago • CCNPWhich IP address is used as destination IP address for Hello messages when OSPFv3 is used to transfer IPv4 routes?ITExamAnswers asked 1 year ago • CCNPWhich LSA type is used to advertise external routes in OSPFv3?ITExamAnswers asked 1 year ago • CCNPWhich CLI commands will enable OSPFv3 authentication? (Choose two.)ITExamAnswers asked 1 year ago • CCNP