IT Questions Bank Refer to the exhibit. A network administrator enters the displayed commands to configure VLAN 30. What is the result of running these commands?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two operations can be performed from the boot loader command line of a Cisco Catalyst switch? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which statement correctly describes an IBSS?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. VLAN 20 was recently added on the network. Users on VLAN 20 on SW1 start complaining that they do not have connectivity to the users on the same VLAN on switch SW2. What should be done to remedy the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Router R1 is connected to a switch through a trunk. What two ways are indicative of how the router handles incoming VLAN traffic? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which type of VLAN would accommodate untagged traffic on a 802.1q trunk port?ITExamAnswers asked 2 years ago • CCNA 3 v4A network administrator is planning the upgrade of an enterprise LAN to feature Layer 3 support for the application of data security policies, aggregated links, and redundant devices and links. Which switches in the hierarchical three-layer design model support these network requirements?ITExamAnswers asked 4 years ago • CCNP, CCNA 3 v4Refer to the exhibit. Switch SWA is not processing VTP advertisments from switch SWB. What can done to correct the error?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which two switch interfaces would be RSTP edge ports? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which statement is true about the status of interface Fa0/1?ITExamAnswers asked 2 years ago • CCNA 3 v4What is the purpose of configuring a switch port as a trunk port?ITExamAnswers asked 2 years ago • CCNA 3 v4Which type of traffic can still be received on a switch interface that is in STP blocking mode?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What can be determined from the configuration of this wireless device?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. If switch SW1 is configured with the four VLANs as shown in the exhibit, how many physical interfaces are needed on router R1 to configure inter-VLAN routing using subinterfaces?ITExamAnswers asked 2 years ago • CCNA 3 v4When port security is used on a switch, which violation mode will cause an SNMP trap to be sent and traffic to be dropped when the number of secure MAC addresses for a port is reached?ITExamAnswers asked 2 years ago • CCNA 3 v4