IT Questions Bank What happens when the crypto key zeroize rsa command is entered on a switch configured with thetransport input ssh command on the vty lines?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator is configuring RT1 for inter-VLAN routing. The switch is configured correctly and is functional. Host1, Host2, and Host3 cannot communicate with each other. Based on the router configuration, what is causing the problem?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v4Why is priority configured in 4096 increments when using PVST+?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The network administrator needs to remove the east-hosts VLAN and use the switch port from that VLAN in one of the existing VLANs. Which two sets of commands should be used when completely removing VLAN 2 from S1-Central while leaving the switch and all its interfaces operational? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4A network administrator enters the enable command at the Switch> prompt of a new switch. What mode will the switch enter?ITExamAnswers asked 2 years ago • CCNA 3 v4What type of message do wireless clients transmit when they are searching for a specific wireless network?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which two settings show the default value of VTP configuration on a Cisco 2960 switch? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The network consists of four hubs and a switch. The hosts connected to each hub are assigned addresses in the respective VLAN as shown. PC1 on VLAN 1 becomes infected with a virus and initiates a continuous IP broadcast. Which hubs will receive the broadcasts?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Users A and B are reporting intermittent connectivity problems. Pre-installation surveys showed strong signal strength from the AP locations to the client locations. Outside electrical interference has been eliminated. What will fix the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator has segmented the network into two VLANs. The connected hosts can only access resources in their own VLAN. What is the most scalable and cost effective solution to allow inter-VLAN communication in this network?ITExamAnswers asked 2 years ago • CCNA 3 v4What are two requirements for configuring inter-VLAN routing using the router-on-a-stick model? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Hosts PC_A and PC_B send traffic simultaneously, and the frames from the transmitting stations collide. What is the last device to receive the collision?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What will allow a host on VLAN 40 on switch X to communicate with a host in VLAN 40 on switch Y?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator issues the show interfaces fastEthernet 0/8 switchport command to check the status of the port. What can be concluded from the output?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator enters the displayed commands to configure VLAN 30. What is the result of running these commands?ITExamAnswers asked 2 years ago • CCNA 3 v4