IT Questions Bank Refer to the exhibit. An administrator documented the output of a CAM table from an Ethernet switch as shown. What action will the switch take when it receives the frame shown at the bottom of the exhibit?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A new host needs to be connected to VLAN 1. Which IP address should be assigned to this new host?ITExamAnswers asked 2 years ago • CCNA 3 v4In which mode is a VTP switch operating if it does not allow for the creation of local VLANs but it does accept VLAN updates from other switches in the same domain?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. VTP pruning is enabled in the VTP domain that is shown. How will switch ST-1 handle Layer 2 broadcast traffic originating from host A on switch ST-C?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which three options correctly identify information that could be associated with this output?(Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Hosts A and B, connected to hub HB1, attempt to transmit a frame at the same time but a collision occurs. Which hosts will receive the collision jamming signal?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator has segmented the network into two VLANs and configured Router1 for inter-VLAN routing. A test of the network, however, shows that hosts on each VLAN can only access local resources and not resources on the other VLAN. What is the most likely cause of this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. After entering the commands in the exhibit, the administrator receives a “password required, but none set” message when attempting to connect to S1. What is the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What is the result of issuing these commands?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What will be the result of the commands that are shown in the exhibit?ITExamAnswers asked 2 years ago • CCNA 3 v4What is the purpose of issuing the command switchport mode access on a switch interface?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Switch SW-A is to be used as a temporary replacement for another switch in the VTP Student domain. What two pieces of information are indicated from the exhibited output? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNA 3 v4A network administrator is implementing VTP in a large campus LAN that contains one hundred switches. What are valid considerations for reliability and administration?ITExamAnswers asked 2 years ago • CCNA 3 v4Company policy requires disabling the command history buffer on network devices. An administrator enters terminal no history size at the command prompt on a Cisco Catalyst switch and receives no error messages back, but the command history buffer is still available. What is the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Which CLI mode allows users to access all device commands, such as those used for configuration, management, and troubleshooting?ITExamAnswers asked 4 years ago • CCNA 3 v4