IT Questions Bank Which wireless technology standard provides the most compatibility with older wireless standards, but has greater performance?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two statements are true regarding wireless security? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4In a WLAN network, why should wireless access points be implemented with each access point using a different channel?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two conditions have favored adoption of 802.11g over 802.11a? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. When configuring the wireless access point, which setting does the network administrator use to configure the unique identifier that client devices use to distinguish this wireless network from others?ITExamAnswers asked 2 years ago • CCNA 3 v4Wireless users on a network complain about poor performance within a small area of a room. Moving away from this area in any direction improves performance dramatically. What is the first step in designing a solution to this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4What wireless security feature allows a network administrator to configure an access point with wireless NIC unique identifiers so that only these NICs can connect to the wireless network?ITExamAnswers asked 2 years ago • CCNA 3 v4What does a wireless access point use to allow WLAN clients to learn which networks are available in a given area?ITExamAnswers asked 2 years ago • CCNA 3 v4What procedure can prevent man-in-the-middle attacks?ITExamAnswers asked 2 years ago • CCNA 3 v4Which function is provided by a wireless access point?ITExamAnswers asked 2 years ago • CCNA 3 v4Which installation method will allow connectivity for a new wireless network?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two statements concerning network security are accurate? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. All devices are configured as shown in the exhibit. PC2 can successfully ping the F0/0 interface on R1. PC2 cannot ping PC1. What might be the reason for this failure?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two statements are true about the interface fa0/0.10 command? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The network administrator correctly configures RTA to perform inter-VLAN routing. The administrator connects RTA to port 0/4 on SW2, but inter-VLAN routing does not work. What could be the possible cause of the problem with the SW2 configuration?ITExamAnswers asked 2 years ago • CCNA 3 v4