IT Questions Bank Which three elements must be used when configuring a router interface for VLAN trunking? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4What distinguishes traditional routing from router-on-a-stick?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Port Fa0/0 on router R1 is connected to port Fa0/1 on switch S1. After the commands shown are entered on both devices, thenetwork administrator determines that the devices on VLAN 2 are unable to ping the devices on VLAN 1. What is the likely problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Devices on the network are connected to a 24-port Layer 2 switch that is configured with VLANs. Switch ports 0/2 to 0/4 are assigned to VLAN 10. Ports 0/5 to 0/8 are assigned to VLAN 20, and ports 0/9 to 0/12 are assigned to VLAN 30. All other ports are assigned to the default VLAN. Which solution allows all VLANs to communicate between each other while minimizing the number of ports necessary to connect the VLANs?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which three statements describe the network designshown in the exhibit? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What two conclusions can be drawn from the output that is shown? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. PC1 has attempted to ping PC2 but has been unsuccessful. What could account for this failure?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The commands for a router to connect to a trunked uplink are shown in the exhibit. A packet is received from IP address 192.168.1.54. The packet destination address is 192.168.1.120. What will the router do with this packet?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which two statements are true about the operation of the subinterfaces? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Switch1 is correctly configured for the VLANs that are displayed in the graphic. The configuration that is shown was applied to RTA to allow for interVLAN connectivity between hosts attached to Switch1. After testing the network, the administrator logged the following report: Why are hosts connected to Fa0/1 through Fa0/5 unable to communicate with hosts in different VLANs?ITExamAnswers asked 2 years ago • CCNA 3 v4In which situation could individual router physical interfaces be used for InterVLAN routing, instead of a router-on-a-stick configuration?ITExamAnswers asked 2 years ago • CCNA 3 v4Which statement is true about ARP when inter-VLAN routing is being used on the network?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. R1 is routing between networks 192.168.10.0/28 and 192.168.30.0/28. PC1 can ping R1 interface F0/1, but cannot ping PC3. What is causing this failure?ITExamAnswers asked 2 years ago • CCNA 3 v4What are the steps which must be completed in order to enable inter-VLAN routing using router-on-a-stick?ITExamAnswers asked 2 years ago • CCNA 3 v4Which three statements are accurate regarding RSTP and STP? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4