IT Questions Bank What speeds up convergence in a network using link-state routing?ITExamAnswers asked 2 years ago • CCNA 2 v4What two events will cause a link state router to send LSPs to all neighbors? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. When Router D is configured to use a link-state routing protocol and is added to the network, what is the first thing that it does to begin learning the network topology?ITExamAnswers asked 2 years ago • CCNA 2 v4Why is it difficult for routing loops to occur in networks that use link-state routing?ITExamAnswers asked 2 years ago • CCNA 2 v4When are link-state packets sent to neighbors?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What does JAX do with link-state packets from ORL?ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following statements describes the bounded updates used by EIGRP?ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following types of routes will be denoted by EX in EIGRP routing table entries? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Which term defines a collection of networks under the administrative control of a single entity that presents a common routing policy to the Internet?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Network 192.168.0.0/28 goes down. What type of packet does Router2 immediately send to Router1 and Router3?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. This is the debug output from 2 directly connected EIGRP routers. They are not forming an adjacency. What is the cause?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which command will advertise the 192.168.1.64/30 network but not the 192.168.1.32 network on router A?ITExamAnswers asked 2 years ago • CCNA 2 v4In which of the following tables does the EIGRP DUAL algorithm store the primary route to a destination?(Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All interfaces have been configured with the bandwidths that are shown in the example Assuming that all routers are using a default configuration of EIGRP as their routing protocol, what packets take from the 172.16.1.0/16 network to the 192.168.200.0/24 network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. EIGRP is the only routing protocol enabled on this network. No static routes are on this router. What can be concluded about network 198.18.1.0/24 from the exhibited output?ITExamAnswers asked 2 years ago • CCNA 2 v4