IT Questions Bank

IT Questions Bank 1

What will a router do if it does not have a default route configured and a packet needs to be forwarded to a destination network that is not listed in the routing table?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
A network administrator has entered the following command: ip route 192.168.10.64 255.255.255.192 serial0/0/1 When the network administrator enters the command show ip route, the route is not in the routing table. What should the administrator do next?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator notices that a correctly entered static route is not in the routing table. What two router commands would an administrator use to determine if the exit interface was up and the next hop address is available? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
A network engineer issues the show cdp neighbor command on several network devices during the process of network documentation. What is the purpose of performing this command?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Refer to the exhibit. A network administrator has developed a Python script on the local Linux machine and is trying to transfer it to the router. However, the transfer fails. Which action resolves this issue?
IT Questions Bank 6IT Administrator asked 3 years ago • 
Which statement describes the sequence of processes executed by a router when it receives a packet from a host to be delivered to a host on another network?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Refer to the exhibit. A junior engineer updated a branch router configuration. Immediately after the change, the engineer receives calls from the help desk that branch personnel cannot reach any network destinations. Which configuration restores service and continues to block 10.1.1.100/32?
IT Questions Bank 6IT Administrator asked 3 years ago • 
A static route has been configured on a router. However, the destination network no longer exists. What should an administrator do to remove the static route from the routing table?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. An engineer cannot copy the IOS.bin. Which action resolves the issue?
IT Questions Bank 6IT Administrator asked 3 years ago • 
A network administrator has entered a static route to an Ethernet LAN that is connected to an adjacent router. However, the route is not shown in the routing table. Which command would the administrator use to verify that the exit interface is up?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is an advantage of implementing BFD?
IT Questions Bank 6IT Administrator asked 3 years ago • 
What is the purpose of the DHCPv6 Guard?
IT Questions Bank 6IT Administrator asked 3 years ago • 
Which sequence correctly identifies the order of the steps that a router will perform when it receives a packet on an Ethernet interface?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Which function does LDP provide in an MPLS topology?
IT Questions Bank 6IT Administrator asked 3 years ago • 
Refer to the exhibit. The administrator noticed that the connection was flapping between the two ISPs instead of switching to ISP2 when the ISP1 failed. Which action resolves the issue?
IT Questions Bank 6IT Administrator asked 3 years ago • 
« Previous1…826827828829830…1,321Next »
Ask Question