Category: CCNA v3.0 (200-125)
How to configure RIPv2? (Choose two) A. Enable RIP* B. Connect RIP to WAN interface C. Enable auto-summary* D. Enable authentication Which two options are requirements for configuring RIPv2 for IPv4 (Choose two)? A. enabling RIP authentication B. connecting RIP to a WAN Interface C. enabling auto route …
Refer to the exhibit. All of the routers in the network are configured with the ip subnet-zero command. Which network addresses should be used for Link A and Network A? (Choose two) A. Network A – 172.16.3.48/26 B. Network A – 172.16.3.128/25* C. Network A – 172.16.3.192/26 D. …
Which two statements about floating static routes are true? (Choose two) A. They are routes to the exact /32 destination address B. They are used when a route to the destination network is missing C. They have a higher administrative distance than the default static route administrative distance* …
Which value is indicated by the next hop in a routing table? A. preference of the route source B. IP address of the remote router for forwarding the packets* C. how the route was learned D. exit interface IP address for forwarding the packets Which component of the …
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of …
Which identification number is valid for an extended ACL? A. 1 B. 64 C. 99 D. 100* E. 299 F. 1099 Which statement about named ACLs is true? A. They support standard and extended ACLs.* B. They are used to filter usernames and passwords for Telnet and SSH. …
Which option is a benefit of switch stacking? A. It provides redundancy with no impact on resource usage. B. It simplifies adding and removing hosts. C. It supports better performance of high-needs applications. D. It provides higher port density with better resource usage.* Which two options describe benefits …
Which step in the router boot process searches for an IOS image to load into the router? A. bootstrap* B. POST C. mini-IOS D. ROMMON mode If a router has four interfaces and each interface is connected to four switches, how many broadcast domains are present on the …
Which type of device can be replaced by the use of subinterfaces for VLAN routing? A. Layer 2 bridge B. Layer 2 switch C. Layer 3 switch* D. router Which technology can enable multiple VLANs to communicate with one another? A. inter-VLAN routing using a Layer 3 switch* …
Refer to the exhibit. While troubleshooting a switch, you executed the “show interface port-channel 1 etherchannel” command and it returned this output. Which information is provided by the Load value? A. the percentage of use of the link B. the preference of the link C. the session count …