IT Questions Bank

IT Questions Bank 1

Which protocol can cause overload on a CPU of a managed device?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What are the benefit of using Netflow? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
Syslog was configured with a level 3 trap. Which 4 types of logs would be generated (Choose four.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which router IOS commands can be used to troubleshoot LAN connectivity problems? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which command displays CPU utilization?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What Netflow component can be applied to an interface to track IPv4 traffic?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What are three reasons to collect Netflow data on a company network? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
What SNMP message alerts the manager to a condition on the network?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What are three factors a network administrator must consider before implementing Netflow in the network?
IT Questions Bank 2ITExamAnswers asked 4 years ago
What is a global command?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. What can be determined about the router from the console output?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago
Refer to the exhibit. A network administrator configures a new router and enters the copy startup- config running-config command on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enters the system configuration dialog as shown. What is the cause of the problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago
Which command would you use on a Cisco router to verify the Layer 3 path to a host?
IT Questions Bank 2ITExamAnswers asked 4 years ago
« Previous1…1,1851,1861,1871,1881,189…1,316Next »
Ask Question