IT Questions Bank Which two are best practices for creating a new IP addressing scheme for a network? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Which range includes all available networks in the 192.168.8.0/21 network?ITExamAnswers asked 8 months ago • CCNA Discovery v4An administrator is configuring IPv6 on a router. The steps that have already been completed are: What is the remaining step to complete the activation of RIPng?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The IT management is adding three VLANs to the wgroup3 switch. The current subnet will be broken down to support 14 hosts for each of the new VLANs. What will the new subnet mask be for these VLANs?ITExamAnswers asked 8 months ago • CCNA Discovery v4Which statement describes MD5 authentication for neighbor authentication?ITExamAnswers asked 8 months ago • CCNA Discovery v4A network administrator is asked to design a new addressing scheme for a corporate network. Presently, there are 850 users at the head office, 220 users at sales, 425 at manufacturing, and 50 at the research site. Which statement defines the correct VLSM addressing map with minimal waste using the 172.17.0.0/16 network?ITExamAnswers asked 8 months ago • CCNA Discovery v4What is a good design practice when developing a hierarchical addressing scheme?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. Which set of router commands is required to turn on unequal-cost load sharing so that RTRA selects the path A-B-E and the lowest cost path A-C-E to the Internet?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. What is the first usable IP address that can be assigned to the WGROUP3 switch?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The IT management has determined that the new subnet for WGROUP3 needs to be broken down into four more subnets. What would the subnet mask be for the four newly created subnets within WGROUP3?ITExamAnswers asked 8 months ago • CCNA Discovery v4After activating IPv6 traffic forwarding, configuring IPv6 addresses, and globally configure RIPng, what is the remaining step to activate RIPng?ITExamAnswers asked 8 months ago • CCNA Discovery v4How many bits make up an IPv6 address?ITExamAnswers asked 8 months ago • CCNA Discovery v4What is another format for the IPv6 address 1080:0000:0000:0000:0000:0000:1267:01A2?ITExamAnswers asked 8 months ago • CCNA Discovery v4A network administrator is using the 10.0.0.0/8 network for the company. The administrator must create a masking scheme to support 750 users at the main office and 620 users at the remote office. What mask should be assigned to the 10.0.0.0/8 network to preserve the most addresses?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. A company has decided to add a new workgroup. If the subnetting scheme for the network uses contiguous blocks of addresses, what subnet is assigned to WGROUP3?ITExamAnswers asked 8 months ago • CCNA Discovery v4